ARM: SAMSUNG: Add GPIO configuration for a range of pins

Add s3c_gpio_cfgpin_range() to configure a range of pins to the given
value. This is useful for a number of blocks where the pins are in order
and saves multiple calls to s3c_gpio_cfgpin().
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>

arch/arm/plat-samsung/gpio-config.c

@@ -41,6 +41,21 @@ int s3c_gpio_cfgpin(unsigned int pin, unsigned int config)
 }
 EXPORT_SYMBOL(s3c_gpio_cfgpin);
 
+int s3c_gpio_cfgpin_range(unsigned int start, unsigned int nr,
+			  unsigned int cfg)
+{
+	int ret;
+
+	for (; nr > 0; nr--, start++) {
+		ret = s3c_gpio_cfgpin(start, cfg);
+		if (ret != 0)
+			return ret;
+	}
+
+	return 0;
+}
+EXPORT_SYMBOL_GPL(s3c_gpio_cfgpin_range);
+
 unsigned s3c_gpio_getcfg(unsigned int pin)
 {
 	struct s3c_gpio_chip *chip = s3c_gpiolib_getchip(pin);

arch/arm/plat-samsung/include/plat/gpio-cfg.h

@@ -108,6 +108,19 @@ extern int s3c_gpio_cfgpin(unsigned int pin, unsigned int to);
  */
 extern unsigned s3c_gpio_getcfg(unsigned int pin);
 
+/**
+ * s3c_gpio_cfgpin_range() - Change the GPIO function for configuring pin range
+ * @start: The pin number to start at
+ * @nr: The number of pins to configure from @start.
+ * @cfg: The configuration for the pin's function
+ *
+ * Call s3c_gpio_cfgpin() for the @nr pins starting at @start.
+ *
+ * @sa s3c_gpio_cfgpin.
+ */
+extern int s3c_gpio_cfgpin_range(unsigned int start, unsigned int nr,
+				 unsigned int cfg);
+
 /* Define values for the pull-{up,down} available for each gpio pin.
  *
  * These values control the state of the weak pull-{up,down} resistors