drm/i915/dp: Power down sink before disable pipe/transcoder clock

Disabling pipe/transcoder clock before power down sink could cause
sink lost signal, causing it to trigger a hotplug to notify source
that link signal was lost.

Cc: Lucas De Marchi <lucas.demarchi@intel.com>
Reviewed-by: default avatarVille Syrjälä <ville.syrjala@linux.intel.com>
Signed-off-by: default avatarJosé Roberto de Souza <jose.souza@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20191202222513.337777-2-jose.souza@intel.com
parent e815aff5
......@@ -3802,12 +3802,12 @@ static void intel_ddi_post_disable_dp(struct intel_encoder *encoder,
enum phy phy = intel_port_to_phy(dev_priv, encoder->port);
if (!is_mst) {
intel_ddi_disable_pipe_clock(old_crtc_state);
/*
* Power down sink before disabling the port, otherwise we end
* up getting interrupts from the sink on detecting link loss.
*/
intel_dp_sink_dpms(intel_dp, DRM_MODE_DPMS_OFF);
intel_ddi_disable_pipe_clock(old_crtc_state);
}
intel_disable_ddi_buf(encoder, old_crtc_state);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment