Commit 50e18af1 authored by David S. Miller's avatar David S. Miller

Merge tag 'wireless-drivers-for-davem-2015-08-04' of...

Merge tag 'wireless-drivers-for-davem-2015-08-04' of git://git.kernel.org/pub/scm/linux/kernel/git/kvalo/wireless-drivers

Kalle Valo says:

====================
iwlwifi:

* a fix for the stuck TFD queue mechanism - it was producing
  noisy false alarms
* a fix for the NIC prepare flow that prevented the driver
  from being able to access the device on certain systems
* a fix for the scan prority handling which allows the
  regular scan to run even if a scheduled scan is already
  running

rsi:

* fix firmware load DMA regression

b43:

* fix extpa_gain check for 2GHz

rtlwifi:

* fix NULL dereference when PCI driver used as an AP
* add missing module parameter declaration for rtl8723be_mod_params.msi_support
====================
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parents 7ba8bd75 741e3b99
......@@ -3728,7 +3728,7 @@ const u32 *b43_nphy_get_tx_gain_table(struct b43_wldev *dev)
switch (phy->rev) {
case 6:
case 5:
if (sprom->fem.ghz5.extpa_gain == 3)
if (sprom->fem.ghz2.extpa_gain == 3)
return b43_ntab_tx_gain_epa_rev3_hi_pwr_2g;
/* fall through */
case 4:
......
......@@ -1023,7 +1023,7 @@ static void iwl_mvm_scan_umac_dwell(struct iwl_mvm *mvm,
cmd->scan_priority =
iwl_mvm_scan_priority(mvm, IWL_SCAN_PRIORITY_EXT_6);
if (iwl_mvm_scan_total_iterations(params) == 0)
if (iwl_mvm_scan_total_iterations(params) == 1)
cmd->ooc_priority =
iwl_mvm_scan_priority(mvm, IWL_SCAN_PRIORITY_EXT_6);
else
......
......@@ -478,10 +478,16 @@ static void iwl_pcie_apm_stop(struct iwl_trans *trans, bool op_mode_leave)
if (trans->cfg->device_family == IWL_DEVICE_FAMILY_7000)
iwl_set_bits_prph(trans, APMG_PCIDEV_STT_REG,
APMG_PCIDEV_STT_VAL_WAKE_ME);
else if (trans->cfg->device_family == IWL_DEVICE_FAMILY_8000)
else if (trans->cfg->device_family == IWL_DEVICE_FAMILY_8000) {
iwl_set_bit(trans, CSR_DBG_LINK_PWR_MGMT_REG,
CSR_RESET_LINK_PWR_MGMT_DISABLED);
iwl_set_bit(trans, CSR_HW_IF_CONFIG_REG,
CSR_HW_IF_CONFIG_REG_PREPARE |
CSR_HW_IF_CONFIG_REG_ENABLE_PME);
mdelay(1);
iwl_clear_bit(trans, CSR_DBG_LINK_PWR_MGMT_REG,
CSR_RESET_LINK_PWR_MGMT_DISABLED);
}
mdelay(5);
}
......@@ -575,6 +581,10 @@ static int iwl_pcie_prepare_card_hw(struct iwl_trans *trans)
if (ret >= 0)
return 0;
iwl_set_bit(trans, CSR_DBG_LINK_PWR_MGMT_REG,
CSR_RESET_LINK_PWR_MGMT_DISABLED);
msleep(1);
for (iter = 0; iter < 10; iter++) {
/* If HW is not ready, prepare the conditions to check again */
iwl_set_bit(trans, CSR_HW_IF_CONFIG_REG,
......@@ -582,8 +592,10 @@ static int iwl_pcie_prepare_card_hw(struct iwl_trans *trans)
do {
ret = iwl_pcie_set_hw_ready(trans);
if (ret >= 0)
return 0;
if (ret >= 0) {
ret = 0;
goto out;
}
usleep_range(200, 1000);
t += 200;
......@@ -593,6 +605,10 @@ static int iwl_pcie_prepare_card_hw(struct iwl_trans *trans)
IWL_ERR(trans, "Couldn't prepare the card\n");
out:
iwl_clear_bit(trans, CSR_DBG_LINK_PWR_MGMT_REG,
CSR_RESET_LINK_PWR_MGMT_DISABLED);
return ret;
}
......
......@@ -1875,8 +1875,19 @@ int iwl_trans_pcie_tx(struct iwl_trans *trans, struct sk_buff *skb,
/* start timer if queue currently empty */
if (q->read_ptr == q->write_ptr) {
if (txq->wd_timeout)
mod_timer(&txq->stuck_timer, jiffies + txq->wd_timeout);
if (txq->wd_timeout) {
/*
* If the TXQ is active, then set the timer, if not,
* set the timer in remainder so that the timer will
* be armed with the right value when the station will
* wake up.
*/
if (!txq->frozen)
mod_timer(&txq->stuck_timer,
jiffies + txq->wd_timeout);
else
txq->frozen_expiry_remainder = txq->wd_timeout;
}
IWL_DEBUG_RPM(trans, "Q: %d first tx - take ref\n", q->id);
iwl_trans_pcie_ref(trans);
}
......
......@@ -172,6 +172,7 @@ static int rsi_load_ta_instructions(struct rsi_common *common)
(struct rsi_91x_sdiodev *)adapter->rsi_dev;
u32 len;
u32 num_blocks;
const u8 *fw;
const struct firmware *fw_entry = NULL;
u32 block_size = dev->tx_blk_size;
int status = 0;
......@@ -200,6 +201,10 @@ static int rsi_load_ta_instructions(struct rsi_common *common)
return status;
}
/* Copy firmware into DMA-accessible memory */
fw = kmemdup(fw_entry->data, fw_entry->size, GFP_KERNEL);
if (!fw)
return -ENOMEM;
len = fw_entry->size;
if (len % 4)
......@@ -210,7 +215,8 @@ static int rsi_load_ta_instructions(struct rsi_common *common)
rsi_dbg(INIT_ZONE, "%s: Instruction size:%d\n", __func__, len);
rsi_dbg(INIT_ZONE, "%s: num blocks: %d\n", __func__, num_blocks);
status = rsi_copy_to_card(common, fw_entry->data, len, num_blocks);
status = rsi_copy_to_card(common, fw, len, num_blocks);
kfree(fw);
release_firmware(fw_entry);
return status;
}
......
......@@ -146,7 +146,10 @@ static int rsi_load_ta_instructions(struct rsi_common *common)
return status;
}
/* Copy firmware into DMA-accessible memory */
fw = kmemdup(fw_entry->data, fw_entry->size, GFP_KERNEL);
if (!fw)
return -ENOMEM;
len = fw_entry->size;
if (len % 4)
......@@ -158,6 +161,7 @@ static int rsi_load_ta_instructions(struct rsi_common *common)
rsi_dbg(INIT_ZONE, "%s: num blocks: %d\n", __func__, num_blocks);
status = rsi_copy_to_card(common, fw, len, num_blocks);
kfree(fw);
release_firmware(fw_entry);
return status;
}
......
......@@ -1015,9 +1015,12 @@ static void send_beacon_frame(struct ieee80211_hw *hw,
{
struct rtl_priv *rtlpriv = rtl_priv(hw);
struct sk_buff *skb = ieee80211_beacon_get(hw, vif);
struct rtl_tcb_desc tcb_desc;
if (skb)
rtlpriv->intf_ops->adapter_tx(hw, NULL, skb, NULL);
if (skb) {
memset(&tcb_desc, 0, sizeof(struct rtl_tcb_desc));
rtlpriv->intf_ops->adapter_tx(hw, NULL, skb, &tcb_desc);
}
}
static void rtl_op_bss_info_changed(struct ieee80211_hw *hw,
......
......@@ -385,6 +385,7 @@ module_param_named(debug, rtl8723be_mod_params.debug, int, 0444);
module_param_named(ips, rtl8723be_mod_params.inactiveps, bool, 0444);
module_param_named(swlps, rtl8723be_mod_params.swctrl_lps, bool, 0444);
module_param_named(fwlps, rtl8723be_mod_params.fwctrl_lps, bool, 0444);
module_param_named(msi, rtl8723be_mod_params.msi_support, bool, 0444);
module_param_named(disable_watchdog, rtl8723be_mod_params.disable_watchdog,
bool, 0444);
MODULE_PARM_DESC(swenc, "Set to 1 for software crypto (default 0)\n");
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment