ath10k: enable wmi ps peer param command for 10.x FW

Enable ap_ps_peer_param_cmdid for 10.x FW.
This is used mainly for AP UAPSD.
Signed-off-by: Janusz Dziedzic <janusz.dziedzic@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath10k/wmi.c

@@ -213,7 +213,7 @@ static struct wmi_cmd_map wmi_10x_cmd_map = {
 	.p2p_go_set_beacon_ie = WMI_10X_P2P_GO_SET_BEACON_IE,
 	.p2p_go_set_probe_resp_ie = WMI_10X_P2P_GO_SET_PROBE_RESP_IE,
 	.p2p_set_vendor_ie_data_cmdid = WMI_CMD_UNSUPPORTED,
-	.ap_ps_peer_param_cmdid = WMI_CMD_UNSUPPORTED,
+	.ap_ps_peer_param_cmdid = WMI_10X_AP_PS_PEER_PARAM_CMDID,
 	.ap_ps_peer_uapsd_coex_cmdid = WMI_CMD_UNSUPPORTED,
 	.peer_rate_retry_sched_cmdid = WMI_10X_PEER_RATE_RETRY_SCHED_CMDID,
 	.wlan_profile_trigger_cmdid = WMI_10X_WLAN_PROFILE_TRIGGER_CMDID,