Commit 615534bc authored by Christian Pellegrin's avatar Christian Pellegrin Committed by David S. Miller

can: fix setting mcp251x bit timing on open

Signed-off-by: default avatarChristian Pellegrin <chripell@fsfe.org>
Signed-off-by: default avatarWolfgang Grandegger <wg@grandegger.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 9a4e328e
......@@ -594,13 +594,7 @@ static int mcp251x_do_set_bittiming(struct net_device *net)
static int mcp251x_setup(struct net_device *net, struct mcp251x_priv *priv,
struct spi_device *spi)
{
int ret;
ret = open_candev(net);
if (ret) {
dev_err(&spi->dev, "unable to set initial baudrate!\n");
return ret;
}
mcp251x_do_set_bittiming(net);
/* Enable RX0->RX1 buffer roll over and disable filters */
mcp251x_write_bits(spi, RXBCTRL(0),
......@@ -671,6 +665,12 @@ static int mcp251x_open(struct net_device *net)
struct mcp251x_platform_data *pdata = spi->dev.platform_data;
int ret;
ret = open_candev(net);
if (ret) {
dev_err(&spi->dev, "unable to set initial baudrate!\n");
return ret;
}
if (pdata->transceiver_enable)
pdata->transceiver_enable(1);
......@@ -684,6 +684,7 @@ static int mcp251x_open(struct net_device *net)
dev_err(&spi->dev, "failed to acquire irq %d\n", spi->irq);
if (pdata->transceiver_enable)
pdata->transceiver_enable(0);
close_candev(net);
return ret;
}
......@@ -692,8 +693,10 @@ static int mcp251x_open(struct net_device *net)
ret = mcp251x_setup(net, priv, spi);
if (ret) {
free_irq(spi->irq, net);
mcp251x_hw_sleep(spi);
if (pdata->transceiver_enable)
pdata->transceiver_enable(0);
close_candev(net);
return ret;
}
mcp251x_set_normal_mode(spi);
......@@ -956,7 +959,6 @@ static int __devinit mcp251x_can_probe(struct spi_device *spi)
priv->can.bittiming_const = &mcp251x_bittiming_const;
priv->can.do_set_mode = mcp251x_do_set_mode;
priv->can.clock.freq = pdata->oscillator_frequency / 2;
priv->can.do_set_bittiming = mcp251x_do_set_bittiming;
priv->net = net;
dev_set_drvdata(&spi->dev, priv);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment