iwlwifi: correctly set the NMI register

When we want to trigger an NMI in the device, we need to set
bit 7 and not bit 0. However, older firmwares don't register
to the interrupt issued by bit 7. Use bit 7 first so that
the correct interrupt will be issued hoping that the firmware
will react. To be on the safe side, set bit 0 in case the
firmware didn't register to the proper interrupt.
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>

drivers/net/wireless/iwlwifi/iwl-io.c

@@ -193,11 +193,15 @@ void iwl_force_nmi(struct iwl_trans *trans)
 	 * DEVICE_SET_NMI_8000B_REG - is used.
 	 */
 	if ((trans->cfg->device_family != IWL_DEVICE_FAMILY_8000) ||
-	    (CSR_HW_REV_STEP(trans->hw_rev) == SILICON_A_STEP))
-		iwl_write_prph(trans, DEVICE_SET_NMI_REG, DEVICE_SET_NMI_VAL);
-	else
+	    (CSR_HW_REV_STEP(trans->hw_rev) == SILICON_A_STEP)) {
+		iwl_write_prph(trans, DEVICE_SET_NMI_REG,
+			       DEVICE_SET_NMI_VAL_DRV);
+		iwl_write_prph(trans, DEVICE_SET_NMI_REG,
+			       DEVICE_SET_NMI_VAL_HW);
+	} else {
 		iwl_write_prph(trans, DEVICE_SET_NMI_8000B_REG,
 			       DEVICE_SET_NMI_8000B_VAL);
+	}
 }
 IWL_EXPORT_SYMBOL(iwl_force_nmi);
 

drivers/net/wireless/iwlwifi/iwl-prph.h

@@ -108,7 +108,8 @@
 
 /* Device NMI register */
 #define DEVICE_SET_NMI_REG 0x00a01c30
-#define DEVICE_SET_NMI_VAL 0x1
+#define DEVICE_SET_NMI_VAL_HW BIT(0)
+#define DEVICE_SET_NMI_VAL_DRV BIT(7)
 #define DEVICE_SET_NMI_8000B_REG 0x00a01c24
 #define DEVICE_SET_NMI_8000B_VAL 0x1000000