Commit 66d90f6e authored by Sudeep Holla's avatar Sudeep Holla

firmware: arm_scmi: Enable building as a single module

Now, with all the plumbing in place to enable building scmi as a module
instead of built-in modules, let us enable the same.

Link: https://lore.kernel.org/r/20200907195046.56615-5-sudeep.holla@arm.comTested-by: default avatarCristian Marussi <cristian.marussi@arm.com>
Signed-off-by: default avatarSudeep Holla <sudeep.holla@arm.com>
parent 1eaf18e3
......@@ -7,7 +7,7 @@
menu "Firmware Drivers"
config ARM_SCMI_PROTOCOL
bool "ARM System Control and Management Interface (SCMI) Message Protocol"
tristate "ARM System Control and Management Interface (SCMI) Message Protocol"
depends on ARM || ARM64 || COMPILE_TEST
depends on MAILBOX
help
......
......@@ -22,7 +22,7 @@ obj-$(CONFIG_TI_SCI_PROTOCOL) += ti_sci.o
obj-$(CONFIG_TRUSTED_FOUNDATIONS) += trusted_foundations.o
obj-$(CONFIG_TURRIS_MOX_RWTM) += turris-mox-rwtm.o
obj-$(CONFIG_ARM_SCMI_PROTOCOL) += arm_scmi/
obj-y += arm_scmi/
obj-y += broadcom/
obj-y += meson/
obj-$(CONFIG_GOOGLE_FIRMWARE) += google/
......
# SPDX-License-Identifier: GPL-2.0-only
obj-y = scmi-bus.o scmi-driver.o scmi-protocols.o scmi-transport.o
scmi-bus-y = bus.o
scmi-driver-y = driver.o notify.o
scmi-transport-y = shmem.o
scmi-transport-$(CONFIG_MAILBOX) += mailbox.o
scmi-transport-$(CONFIG_HAVE_ARM_SMCCC_DISCOVERY) += smc.o
scmi-protocols-y = base.o clock.o perf.o power.o reset.o sensors.o system.o
scmi-module-objs := $(scmi-bus-y) $(scmi-driver-y) $(scmi-protocols-y) \
$(scmi-transport-y)
obj-$(CONFIG_ARM_SCMI_PROTOCOL) += scmi-module.o
obj-$(CONFIG_ARM_SCMI_POWER_DOMAIN) += scmi_pm_domain.o
......@@ -345,7 +345,7 @@ struct scmi_driver {
#define to_scmi_driver(d) container_of(d, struct scmi_driver, driver)
#ifdef CONFIG_ARM_SCMI_PROTOCOL
#if IS_REACHABLE(CONFIG_ARM_SCMI_PROTOCOL)
int scmi_driver_register(struct scmi_driver *driver,
struct module *owner, const char *mod_name);
void scmi_driver_unregister(struct scmi_driver *driver);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment