arm64: dts: renesas: salvator-common: enable usb3_peri0

This patch enables usb3_peri0 that uses usb3_phy0 to enable VBUS
detection for the USB3.0 peripheral.

The Salvator-X[S] has USB3.0 type-A connector and supplies VBUS
if USB3.0 host runs. So, you need a special cable for it, and
to stop the VBUS supplies from the board, after you installs
a gadget driver, you should run the following command to avoid
conflict VBUS supply:

	# echo 1 > /sys/kernel/debug/ee020000.usb/b_device
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Signed-off-by: Simon Horman <horms+renesas@verge.net.au>

arch/arm64/boot/dts/renesas/salvator-common.dtsi

@@ -667,6 +667,13 @@ &usb2_phy1 {
 	status = "okay";
 };
 
+&usb3_peri0 {
+	phys = <&usb3_phy0>;
+	phy-names = "usb";
+
+	status = "okay";
+};
+
 &usb3_phy0 {
 	status = "okay";
 };