ARM: at91: fix external interrupt specification in board code

Since the switch to sparse irq, we have to add the NR_IRQS_LEGACY
offset to static irq numbers. It has been forgotten on these
SPI irq definitions in board code.
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Acked-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Ludovic Desroches <ludovic.desroches@atmel.com>
Cc: stable <stable@vger.kernel.org> [v3.6]

arch/arm/mach-at91/board-neocore926.c

@@ -129,7 +129,7 @@ static struct spi_board_info neocore926_spi_devices[] = {
 		.max_speed_hz	= 125000 * 16,
 		.bus_num	= 0,
 		.platform_data	= &ads_info,
-		.irq		= AT91SAM9263_ID_IRQ1,
+		.irq		= NR_IRQS_LEGACY + AT91SAM9263_ID_IRQ1,
 	},
 #endif
 };

arch/arm/mach-at91/board-sam9261ek.c

@@ -309,7 +309,7 @@ static struct spi_board_info ek_spi_devices[] = {
 		.max_speed_hz	= 125000 * 26,	/* (max sample rate @ 3V) * (cmd + data + overhead) */
 		.bus_num	= 0,
 		.platform_data	= &ads_info,
-		.irq		= AT91SAM9261_ID_IRQ0,
+		.irq		= NR_IRQS_LEGACY + AT91SAM9261_ID_IRQ0,
 		.controller_data = (void *) AT91_PIN_PA28,	/* CS pin */
 	},
 #endif

arch/arm/mach-at91/board-sam9263ek.c

@@ -132,7 +132,7 @@ static struct spi_board_info ek_spi_devices[] = {
 		.max_speed_hz	= 125000 * 26,	/* (max sample rate @ 3V) * (cmd + data + overhead) */
 		.bus_num	= 0,
 		.platform_data	= &ads_info,
-		.irq		= AT91SAM9263_ID_IRQ1,
+		.irq		= NR_IRQS_LEGACY + AT91SAM9263_ID_IRQ1,
 	},
 #endif
 };