usb: plusb: Add support for PL-27A1

This patch adds support for the PL-27A1 by adding the appropriate
USB ID's. This chip is used in the goobay Active USB 3.0 Data Link
and Unitek Y-3501 cables.
Signed-off-by: Roman Spychała <roed@onet.eu>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/usb/Kconfig

@@ -369,7 +369,7 @@ config USB_NET_NET1080
 	  optionally with LEDs that indicate traffic
 
 config USB_NET_PLUSB
-	tristate "Prolific PL-2301/2302/25A1 based cables"
+	tristate "Prolific PL-2301/2302/25A1/27A1 based cables"
 	# if the handshake/init/reset problems, from original 'plusb',
 	# are ever resolved ... then remove "experimental"
 	depends on USB_USBNET

drivers/net/usb/plusb.c

@@ -102,7 +102,7 @@ static int pl_reset(struct usbnet *dev)
 }
 
 static const struct driver_info	prolific_info = {
-	.description =	"Prolific PL-2301/PL-2302/PL-25A1",
+	.description =	"Prolific PL-2301/PL-2302/PL-25A1/PL-27A1",
 	.flags =	FLAG_POINTTOPOINT | FLAG_NO_SETINT,
 		/* some PL-2302 versions seem to fail usb_set_interface() */
 	.reset =	pl_reset,
@@ -139,6 +139,17 @@ static const struct usb_device_id	products [] = {
 					 * Host-to-Host Cable
 					 */
 	.driver_info =  (unsigned long) &prolific_info,
+
+},
+
+/* super speed cables */
+{
+	USB_DEVICE(0x067b, 0x27a1),     /* PL-27A1, no eeprom
+					 * also: goobay Active USB 3.0
+					 * Data Link,
+					 * Unitek Y-3501
+					 */
+	.driver_info =  (unsigned long) &prolific_info,
 },
 
 	{ },		// END
@@ -158,5 +169,5 @@ static struct usb_driver plusb_driver = {
 module_usb_driver(plusb_driver);
 
 MODULE_AUTHOR("David Brownell");
-MODULE_DESCRIPTION("Prolific PL-2301/2302/25A1 USB Host to Host Link Driver");
+MODULE_DESCRIPTION("Prolific PL-2301/2302/25A1/27A1 USB Host to Host Link Driver");
 MODULE_LICENSE("GPL");