phy: qcom-usb: Remove unused ulpi phy header

Ulpi phy header is not used for anything. Remove the same
from qcom-hs and qcom-hsic phy drivers.
Signed-off-by: Vivek Gautam <vivek.gautam@codeaurora.org>
Suggested-by: Stephen Boyd <stephen.boyd@linaro.org>
Cc: Kishon Vijay Abraham I <kishon@ti.com>
Cc: linux-arm-kernel@lists.infradead.org
Cc: linux-arm-msm@vger.kernel.org
Cc: linux-kernel@vger.kernel.org
Cc: linux-usb@vger.kernel.org
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>

drivers/phy/phy-qcom-usb-hs.c

@@ -11,12 +11,11 @@
 #include <linux/clk.h>
 #include <linux/regulator/consumer.h>
 #include <linux/of_device.h>
+#include <linux/phy/phy.h>
 #include <linux/reset.h>
 #include <linux/extcon.h>
 #include <linux/notifier.h>
 
-#include "ulpi_phy.h"
-
 #define ULPI_PWR_CLK_MNG_REG		0x88
 # define ULPI_PWR_OTG_COMP_DISABLE	BIT(0)
 

drivers/phy/phy-qcom-usb-hsic.c

@@ -8,13 +8,12 @@
 #include <linux/module.h>
 #include <linux/ulpi/driver.h>
 #include <linux/ulpi/regs.h>
+#include <linux/phy/phy.h>
 #include <linux/pinctrl/consumer.h>
 #include <linux/pinctrl/pinctrl-state.h>
 #include <linux/delay.h>
 #include <linux/clk.h>
 
-#include "ulpi_phy.h"
-
 #define ULPI_HSIC_CFG		0x30
 #define ULPI_HSIC_IO_CAL	0x33