Merge branch 'stmmac_pm'

Srinivas Kandagatla says:

====================
net: stmmac PM related fixes.

During PM_SUSPEND_FREEZE testing, I have noticed that PM support in STMMAC is
partly broken. I had to re-arrange the code to do PM correctly. There were lot
of things I did not like personally and some bits did not work in the first
place. I thought this is the nice opportunity to clean the mess up.

Here is what I did:
 any
1> Test PM suspend freeze via pm_test
It did not work for following reasons.
 - If the power to gmac is removed when it enters in low power state.
stmmac_resume could not cope up with such behaviour, it was expecting the ip
register contents to be still same as before entering low power, This
assumption is wrong. So I started to add some code to do Hardware
initialization, thats when I started to re-arrange the code. stmmac_open
contains both resource and memory allocations and hardware initialization. I
had to separate these two things in two different functions.

These two patches do that
  net: stmmac: move dma allocation to new function
  net: stmmac: move hardware setup for stmmac_open to new function

And rest of the other patches are fixing the loose ends, things like mdio
reset, which might be necessary in cases likes hibernation(I did not test).

In hibernation cases the driver was just unregistering with subsystems and
releasing resources which I did not like and its not necessary to do this as
part of PM. So using the same stmmac_suspend/resume made more sense for
hibernation cases than using stmmac_open/release.
Also fixed a NULL pointer dereference bug too.

2> Test WOL via PM_SUSPEND_FREEZE
Did get an wakeup interrupt, but could not wakeup a freeze system.
So I had to add pm_wakeup_event to the driver.
net: stmmac: notify the PM core of a wakeup event. patch.

Also few patches like
  net: stmmac: make stmmac_mdio_reset non-static
  net: stmmac: restore pinstate in pm resume.
helps the resume function to reset the phy and put back the pins in default
state.

Changes since RFC:
	- Rebased to net-next on Dave's suggestion.

All these patches are Acked by Peppe.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/stmicro/stmmac/stmmac.h

@@ -105,19 +105,19 @@ struct stmmac_priv {
 	unsigned int default_addend;
 	u32 adv_ts;
 	int use_riwt;
+	int irq_wake;
 	spinlock_t ptp_lock;
 };
 
 int stmmac_mdio_unregister(struct net_device *ndev);
 int stmmac_mdio_register(struct net_device *ndev);
+int stmmac_mdio_reset(struct mii_bus *mii);
 void stmmac_set_ethtool_ops(struct net_device *netdev);
 extern const struct stmmac_desc_ops enh_desc_ops;
 extern const struct stmmac_desc_ops ndesc_ops;
 extern const struct stmmac_hwtimestamp stmmac_ptp;
 int stmmac_ptp_register(struct stmmac_priv *priv);
 void stmmac_ptp_unregister(struct stmmac_priv *priv);
-int stmmac_freeze(struct net_device *ndev);
-int stmmac_restore(struct net_device *ndev);
 int stmmac_resume(struct net_device *ndev);
 int stmmac_suspend(struct net_device *ndev);
 int stmmac_dvr_remove(struct net_device *ndev);

drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c

@@ -128,7 +128,7 @@ static int stmmac_mdio_write(struct mii_bus *bus, int phyaddr, int phyreg,
  * @bus: points to the mii_bus structure
  * Description: reset the MII bus
  */
-static int stmmac_mdio_reset(struct mii_bus *bus)
+int stmmac_mdio_reset(struct mii_bus *bus)
 {
 #if defined(CONFIG_STMMAC_PLATFORM)
 	struct net_device *ndev = bus->priv;
@@ -166,7 +166,6 @@ static int stmmac_mdio_reset(struct mii_bus *bus)
 			udelay(data->delays[1]);
 			gpio_set_value(reset_gpio, active_low ? 1 : 0);
 			udelay(data->delays[2]);
-			gpio_free(reset_gpio);
 		}
 	}
 #endif

drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c

@@ -42,6 +42,10 @@ static int stmmac_probe_config_dt(struct platform_device *pdev,
 	*mac = of_get_mac_address(np);
 	plat->interface = of_get_phy_mode(np);
 
+	/* Get max speed of operation from device tree */
+	if (of_property_read_u32(np, "max-speed", &plat->max_speed))
+		plat->max_speed = -1;
+
 	plat->bus_id = of_alias_get_id(np, "ethernet");
 	if (plat->bus_id < 0)
 		plat->bus_id = 0;
@@ -206,56 +210,36 @@ static int stmmac_pltfr_remove(struct platform_device *pdev)
 
 #ifdef CONFIG_PM
 static int stmmac_pltfr_suspend(struct device *dev)
-{
-	struct net_device *ndev = dev_get_drvdata(dev);
-
-	return stmmac_suspend(ndev);
-}
-
-static int stmmac_pltfr_resume(struct device *dev)
-{
-	struct net_device *ndev = dev_get_drvdata(dev);
-
-	return stmmac_resume(ndev);
-}
-
-static int stmmac_pltfr_freeze(struct device *dev)
 {
 	int ret;
-	struct plat_stmmacenet_data *plat_dat = dev_get_platdata(dev);
 	struct net_device *ndev = dev_get_drvdata(dev);
+	struct stmmac_priv *priv = netdev_priv(ndev);
 	struct platform_device *pdev = to_platform_device(dev);
 
-	ret = stmmac_freeze(ndev);
-	if (plat_dat->exit)
-		plat_dat->exit(pdev);
+	ret = stmmac_suspend(ndev);
+	if (priv->plat->exit)
+		priv->plat->exit(pdev);
 
 	return ret;
 }
 
-static int stmmac_pltfr_restore(struct device *dev)
+static int stmmac_pltfr_resume(struct device *dev)
 {
-	struct plat_stmmacenet_data *plat_dat = dev_get_platdata(dev);
 	struct net_device *ndev = dev_get_drvdata(dev);
+	struct stmmac_priv *priv = netdev_priv(ndev);
 	struct platform_device *pdev = to_platform_device(dev);
 
-	if (plat_dat->init)
-		plat_dat->init(pdev);
+	if (priv->plat->init)
+		priv->plat->init(pdev);
 
-	return stmmac_restore(ndev);
+	return stmmac_resume(ndev);
 }
 
-static const struct dev_pm_ops stmmac_pltfr_pm_ops = {
-	.suspend = stmmac_pltfr_suspend,
-	.resume = stmmac_pltfr_resume,
-	.freeze = stmmac_pltfr_freeze,
-	.thaw = stmmac_pltfr_restore,
-	.restore = stmmac_pltfr_restore,
-};
-#else
-static const struct dev_pm_ops stmmac_pltfr_pm_ops;
 #endif /* CONFIG_PM */
 
+static SIMPLE_DEV_PM_OPS(stmmac_pltfr_pm_ops,
+			stmmac_pltfr_suspend, stmmac_pltfr_resume);
+
 static const struct of_device_id stmmac_dt_ids[] = {
 	{ .compatible = "st,spear600-gmac"},
 	{ .compatible = "snps,dwmac-3.610"},

include/linux/stmmac.h

@@ -110,6 +110,7 @@ struct plat_stmmacenet_data {
 	int force_sf_dma_mode;
 	int force_thresh_dma_mode;
 	int riwt_off;
+	int max_speed;
 	void (*fix_mac_speed)(void *priv, unsigned int speed);
 	void (*bus_setup)(void __iomem *ioaddr);
 	int (*init)(struct platform_device *pdev);