Commit 84f6a95a authored by Bing Zhao's avatar Bing Zhao Committed by John W. Linville

mwifiex: make use of is_zero_ether_addr()

Use is_zero_ether_addr() instead of directly using memcmp() to
determine if the ethernet address is all zeros.

Cc: Wei Yongjun <yongjun_wei@trendmicro.com.cn>
Signed-off-by: default avatarBing Zhao <bzhao@marvell.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent a3c2c4f6
......@@ -726,7 +726,6 @@ mwifiex_config_scan(struct mwifiex_private *priv,
struct mwifiex_ie_types_num_probes *num_probes_tlv;
struct mwifiex_ie_types_wildcard_ssid_params *wildcard_ssid_tlv;
struct mwifiex_ie_types_rates_param_set *rates_tlv;
const u8 zero_mac[ETH_ALEN] = { 0, 0, 0, 0, 0, 0 };
u8 *tlv_pos;
u32 num_probes;
u32 ssid_len;
......@@ -840,8 +839,7 @@ mwifiex_config_scan(struct mwifiex_private *priv,
* or BSSID filter applied to the scan results in the firmware.
*/
if ((i && ssid_filter) ||
memcmp(scan_cfg_out->specific_bssid, &zero_mac,
sizeof(zero_mac)))
!is_zero_ether_addr(scan_cfg_out->specific_bssid))
*filtered_scan = true;
} else {
scan_cfg_out->bss_mode = (u8) adapter->scan_mode;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment