Commit 86116f4d authored by Pawel Dembicki's avatar Pawel Dembicki Committed by David S. Miller

net: dsa: Change DT bindings for Vitesse VSC73xx switches

This commit introduce how to use vsc73xx platform driver.
Signed-off-by: default avatarPawel Dembicki <paweldembicki@gmail.com>
Reviewed-by: default avatarLinus Walleij <linus.walleij@linaro.org>
Reviewed-by: default avatarFlorian Fainelli <f.fainelli@gmail.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 30a4616c
......@@ -2,8 +2,8 @@ Vitesse VSC73xx Switches
========================
This defines device tree bindings for the Vitesse VSC73xx switch chips.
The Vitesse company has been acquired by Microsemi and Microsemi in turn
acquired by Microchip but retains this vendor branding.
The Vitesse company has been acquired by Microsemi and Microsemi has
been acquired Microchip but retains this vendor branding.
The currently supported switch chips are:
Vitesse VSC7385 SparX-G5 5+1-port Integrated Gigabit Ethernet Switch
......@@ -11,8 +11,14 @@ Vitesse VSC7388 SparX-G8 8-port Integrated Gigabit Ethernet Switch
Vitesse VSC7395 SparX-G5e 5+1-port Integrated Gigabit Ethernet Switch
Vitesse VSC7398 SparX-G8e 8-port Integrated Gigabit Ethernet Switch
The device tree node is an SPI device so it must reside inside a SPI bus
device tree node, see spi/spi-bus.txt
This switch could have two different management interface.
If SPI interface is used, the device tree node is an SPI device so it must
reside inside a SPI bus device tree node, see spi/spi-bus.txt
When the chip is connected to a parallel memory bus and work in memory-mapped
I/O mode, a platform device is used to represent the vsc73xx. In this case it
must reside inside a platform bus device tree node.
Required properties:
......@@ -38,6 +44,7 @@ and subnodes of DSA switches.
Examples:
SPI:
switch@0 {
compatible = "vitesse,vsc7395";
reg = <0>;
......@@ -79,3 +86,46 @@ switch@0 {
};
};
};
Platform:
switch@2,0 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "vitesse,vsc7385";
reg = <0x2 0x0 0x20000>;
reset-gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
ports {
#address-cells = <1>;
#size-cells = <0>;
port@0 {
reg = <0>;
label = "lan1";
};
port@1 {
reg = <1>;
label = "lan2";
};
port@2 {
reg = <2>;
label = "lan3";
};
port@3 {
reg = <3>;
label = "lan4";
};
vsc: port@6 {
reg = <6>;
label = "cpu";
ethernet = <&enet0>;
phy-mode = "rgmii";
fixed-link {
speed = <1000>;
full-duplex;
pause;
};
};
};
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment