Commit 96576a9e authored by Kulikov Vasiliy's avatar Kulikov Vasiliy Committed by Dave Airlie

agp: intel-agp: do not use PCI resources before pci_enable_device()

IRQ and resource[] may not have correct values until
after PCI hotplug setup occurs at pci_enable_device() time.

The semantic match that finds this problem is as follows:

// <smpl>
@@
identifier x;
identifier request ~= "pci_request.*|pci_resource.*";
@@

(
* x->irq
|
* x->resource
|
* request(x, ...)
)
 ...
*pci_enable_device(x)
// </smpl>
Signed-off-by: default avatarKulikov Vasiliy <segooon@gmail.com>
Signed-off-by: default avatarDave Airlie <airlied@redhat.com>
parent 46cfc58a
......@@ -907,6 +907,17 @@ static int __devinit agp_intel_probe(struct pci_dev *pdev,
dev_info(&pdev->dev, "Intel %s Chipset\n", intel_agp_chipsets[i].name);
/*
* If the device has not been properly setup, the following will catch
* the problem and should stop the system from crashing.
* 20030610 - hamish@zot.org
*/
if (pci_enable_device(pdev)) {
dev_err(&pdev->dev, "can't enable PCI device\n");
agp_put_bridge(bridge);
return -ENODEV;
}
/*
* The following fixes the case where the BIOS has "forgotten" to
* provide an address range for the GART.
......@@ -921,17 +932,6 @@ static int __devinit agp_intel_probe(struct pci_dev *pdev,
}
}
/*
* If the device has not been properly setup, the following will catch
* the problem and should stop the system from crashing.
* 20030610 - hamish@zot.org
*/
if (pci_enable_device(pdev)) {
dev_err(&pdev->dev, "can't enable PCI device\n");
agp_put_bridge(bridge);
return -ENODEV;
}
/* Fill in the mode register */
if (cap_ptr) {
pci_read_config_dword(pdev,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment