spi: zynq-qspi: Keep the naming consistent across the driver

In this driver (and also in a lot of other drivers in drivers/spi/),
the spi_controller structure is sometimes referred as 'ctlr' and
sometimes as 'ctrl'. Grepping there shows that 'ctlr' seems to be more
common so keep the naming consistent in this driver and s/ctrl/ctlr/.
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Link: https://lore.kernel.org/r/20191108105920.19014-3-miquel.raynal@bootlin.comSigned-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spi-zynq-qspi.c

@@ -283,8 +283,8 @@ static void zynq_qspi_txfifo_op(struct zynq_qspi *xqspi, unsigned int size)
  */
 static void zynq_qspi_chipselect(struct spi_device *spi, bool assert)
 {
-	struct spi_controller *ctrl = spi->master;
-	struct zynq_qspi *xqspi = spi_controller_get_devdata(ctrl);
+	struct spi_controller *ctlr = spi->master;
+	struct zynq_qspi *xqspi = spi_controller_get_devdata(ctlr);
 	u32 config_reg;
 
 	config_reg = zynq_qspi_read(xqspi, ZYNQ_QSPI_CONFIG_OFFSET);
@@ -364,10 +364,10 @@ static int zynq_qspi_config_op(struct zynq_qspi *xqspi, struct spi_device *spi)
  */
 static int zynq_qspi_setup_op(struct spi_device *spi)
 {
-	struct spi_controller *ctrl = spi->master;
-	struct zynq_qspi *qspi = spi_controller_get_devdata(ctrl);
+	struct spi_controller *ctlr = spi->master;
+	struct zynq_qspi *qspi = spi_controller_get_devdata(ctlr);
 
-	if (ctrl->busy)
+	if (ctlr->busy)
 		return -EBUSY;
 
 	clk_enable(qspi->refclk);