Commit 9d556bb4 authored by Mike Looijmans's avatar Mike Looijmans Committed by Sebastian Reichel

dt-bindings: power: supply: New bindings for ltc3651-charger

This adds the devicetree bindings documentation for the LTC3651 battery charger.
Signed-off-by: default avatarMike Looijmans <mike.looijmans@topic.nl>
Acked-by: default avatarRob Herring <robh@kernel.org>
Signed-off-by: default avatarSebastian Reichel <sebastian.reichel@collabora.co.uk>
parent 70c9fc9a
ltc3651-charger
Required properties:
- compatible: "lltc,ltc3651-charger"
- lltc,acpr-gpios: Connect to ACPR output. See remark below.
Optional properties:
- lltc,fault-gpios: Connect to FAULT output. See remark below.
- lltc,chrg-gpios: Connect to CHRG output. See remark below.
The ltc3651 outputs are open-drain type and active low. The driver assumes the
GPIO reports "active" when the output is asserted, so if the pins have been
connected directly, the GPIO flags should be set to active low also.
The driver will attempt to aquire interrupts for all GPIOs to detect changes in
line state. If the system is not capabale of providing interrupts, the driver
cannot report changes and userspace will need to periodically read the sysfs
attributes to detect changes.
Example:
charger: battery-charger {
compatible = "lltc,ltc3651-charger";
lltc,acpr-gpios = <&gpio0 68 GPIO_ACTIVE_LOW>;
lltc,fault-gpios = <&gpio0 64 GPIO_ACTIVE_LOW>;
lltc,chrg-gpios = <&gpio0 63 GPIO_ACTIVE_LOW>;
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment