net: qcom/emac: display the phy driver info after we connect

The PHY driver is attached only when the driver calls
phy_connect_direct().  Calling phy_attached_print() to display
information about the PHY driver prior to that point is meaningless.
The interface can be brought down, a new PHY driver can be loaded,
and the interface then brought back up.  This is the correct time
to display information about the attached driver.

Since phy_attached_print() also prints information about the
interrupt, that needs to be set as well.
Signed-off-by: Timur Tabi <timur@codeaurora.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/qualcomm/emac/emac-mac.c

@@ -981,6 +981,7 @@ int emac_mac_up(struct emac_adapter *adpt)
 	emac_mac_config(adpt);
 	emac_mac_rx_descs_refill(adpt, &adpt->rx_q);
 
+	adpt->phydev->irq = PHY_IGNORE_INTERRUPT;
 	ret = phy_connect_direct(netdev, adpt->phydev, emac_adjust_link,
 				 PHY_INTERFACE_MODE_SGMII);
 	if (ret) {
@@ -988,11 +989,12 @@ int emac_mac_up(struct emac_adapter *adpt)
 		return ret;
 	}
 
+	phy_attached_print(adpt->phydev, NULL);
+
 	/* enable mac irq */
 	writel((u32)~DIS_INT, adpt->base + EMAC_INT_STATUS);
 	writel(adpt->irq.mask, adpt->base + EMAC_INT_MASK);
 
-	adpt->phydev->irq = PHY_IGNORE_INTERRUPT;
 	phy_start(adpt->phydev);
 
 	napi_enable(&adpt->rx_q.napi);

drivers/net/ethernet/qualcomm/emac/emac-phy.c

@@ -226,8 +226,5 @@ int emac_phy_config(struct platform_device *pdev, struct emac_adapter *adpt)
 		return -ENODEV;
 	}
 
-	if (adpt->phydev->drv)
-		phy_attached_print(adpt->phydev, NULL);
-
 	return 0;
 }