ARM: sun6i: Enable USB Host support on the Colombus board

The colombus board has a on-board USB hub, that is enabled through the pin
PH24, and wired to the first EHCI controller.
Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>

arch/arm/boot/dts/sun6i-a31-colombus.dts

@@ -13,6 +13,7 @@
 
 /dts-v1/;
 /include/ "sun6i-a31.dtsi"
+/include/ "sunxi-common-regulators.dtsi"
 
 / {
 	model = "WITS A31 Colombus Evaluation Board";
@@ -23,6 +24,24 @@ chosen {
 	};
 
 	soc@01c00000 {
+		usbphy: phy@01c19400 {
+			usb2_vbus-supply = <&reg_usb2_vbus>;
+			status = "okay";
+		};
+
+		ehci1: usb@01c1b000 {
+			status = "okay";
+		};
+
+		pio: pinctrl@01c20800 {
+			usb2_vbus_pin_colombus: usb2_vbus_pin@0 {
+				allwinner,pins = "PH24";
+				allwinner,function = "gpio_out";
+				allwinner,drive = <0>;
+				allwinner,pull = <0>;
+			};
+		};
+
 		uart0: serial@01c28000 {
 			pinctrl-names = "default";
 			pinctrl-0 = <&uart0_pins_a>;
@@ -47,4 +66,11 @@ i2c2: i2c@01c2b400 {
 			status = "okay";
 		};
 	};
+
+	reg_usb2_vbus: usb2-vbus {
+		pinctrl-names = "default";
+		pinctrl-0 = <&usb2_vbus_pin_colombus>;
+		gpio = <&pio 7 24 0>;
+		status = "okay";
+	};
 };