r8152: set rx mode early when linking on

Set rx mode before calling netif_wake_queue() when linking on to avoid
the device missing the receiving packets.

The transmission may start after calling netif_wake_queue(), and the
packets of resopnse may reach before calling rtl8152_set_rx_mode()
which let the device could receive packets. Then, the packets of
response would be missed.
Signed-off-by: Hayes Wang <hayeswang@realtek.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/usb/r8152.c

@@ -3795,11 +3795,12 @@ static void set_carrier(struct r8152 *tp)
 	if (speed & LINK_STATUS) {
 		if (!netif_carrier_ok(netdev)) {
 			tp->rtl_ops.enable(tp);
-			set_bit(RTL8152_SET_RX_MODE, &tp->flags);
 			netif_stop_queue(netdev);
 			napi_disable(napi);
 			netif_carrier_on(netdev);
 			rtl_start_rx(tp);
+			clear_bit(RTL8152_SET_RX_MODE, &tp->flags);
+			_rtl8152_set_rx_mode(netdev);
 			napi_enable(&tp->napi);
 			netif_wake_queue(netdev);
 			netif_info(tp, link, netdev, "carrier on\n");
@@ -4259,7 +4260,7 @@ static int rtl8152_post_reset(struct usb_interface *intf)
 		mutex_lock(&tp->control);
 		tp->rtl_ops.enable(tp);
 		rtl_start_rx(tp);
-		rtl8152_set_rx_mode(netdev);
+		_rtl8152_set_rx_mode(netdev);
 		mutex_unlock(&tp->control);
 	}