OMAPDSS: n8x0 panel: remove use of platform_enable/disable

The n8x0 panel driver now manages the gpios required to configure the panel.
This was previously done in panel_n8x0_data's platform_enable/disable callbacks
defined in board files using this panel.

All the board files using this panel now pass the gpio information as platform
data via the panel_n8x0_data struct, which is needed by the panel driver to
configure the gpios connected to the panel. Hence, the uses of
platform_enable/disable ops can be safely removed now.
Signed-off-by: Archit Taneja <archit@ti.com>

drivers/video/omap2/displays/panel-n8x0.c

@@ -295,12 +295,6 @@ static int n8x0_panel_power_on(struct omap_dss_device *dssdev)
 
 	gpio_direction_output(bdata->ctrl_pwrdown, 1);
 
-	if (bdata->platform_enable) {
-		r = bdata->platform_enable(dssdev);
-		if (r)
-			goto err_plat_en;
-	}
-
 	omapdss_rfbi_set_size(dssdev, dssdev->panel.timings.x_res,
 		dssdev->panel.timings.y_res);
 	omapdss_rfbi_set_pixel_size(dssdev, dssdev->ctrl.pixel_size);
@@ -373,9 +367,6 @@ static int n8x0_panel_power_on(struct omap_dss_device *dssdev)
 err_inv_chip:
 	omapdss_rfbi_display_disable(dssdev);
 err_rfbi_en:
-	if (bdata->platform_disable)
-		bdata->platform_disable(dssdev);
-err_plat_en:
 	gpio_direction_output(bdata->ctrl_pwrdown, 0);
 	return r;
 }
@@ -392,9 +383,6 @@ static void n8x0_panel_power_off(struct omap_dss_device *dssdev)
 	send_display_off(spi);
 	send_sleep_in(spi);
 
-	if (bdata->platform_disable)
-		bdata->platform_disable(dssdev);
-
 	/*
 	 * HACK: we should turn off the panel here, but there is some problem
 	 * with the initialization sequence, and we fail to init the panel if we