solos-pci: Fix DMA support

DMA support has finally made its way to the top of the TODO list, having
realised that a Geode using MMIO can't keep up with two ADSL2+ lines
each running at 21Mb/s.

This patch fixes a couple of bugs in the DMA support in the driver, so
once the corresponding FPGA update is complete and tested everything
should work properly.

We weren't storing the currently-transmitting skb, so we were never
unmapping it and never freeing/popping it when the TX was done.
And the addition of pci_set_master() is fairly self-explanatory.
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
Cc: stable@kernel.org
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/atm/solos-pci.c

@@ -984,6 +984,7 @@ static uint32_t fpga_tx(struct solos_card *card)
 			} else if (skb && card->using_dma) {
 				SKB_CB(skb)->dma_addr = pci_map_single(card->dev, skb->data,
 								       skb->len, PCI_DMA_TODEVICE);
+				card->tx_skb[port] = skb;
 				iowrite32(SKB_CB(skb)->dma_addr,
 					  card->config_regs + TX_DMA_ADDR(port));
 			}
@@ -1152,7 +1153,8 @@ static int fpga_probe(struct pci_dev *dev, const struct pci_device_id *id)
 		db_fpga_upgrade = db_firmware_upgrade = 0;
 	}
 
-	if (card->fpga_version >= DMA_SUPPORTED){
+	if (card->fpga_version >= DMA_SUPPORTED) {
+		pci_set_master(dev);
 		card->using_dma = 1;
 	} else {
 		card->using_dma = 0;