Commit b61b8b37 authored by Pierre-Louis Bossart's avatar Pierre-Louis Bossart Committed by Vinod Koul

soundwire: intel: reset pm_runtime status during system resume

The system resume does the entire bus re-initialization and brings it
to full-power. If the device was pm_runtime suspended, there is no
need to run the pm_runtime resume sequence after the system runtime.

Follow the documentation from runtime_pm.rst, and conditionally
disable, set_active and re-enable the device on system resume.

Note that pm_runtime_suspended() is used instead of
pm_runtime_status_suspended() so that we can deal with the case where
pm_runtime is disabled.
Signed-off-by: default avatarPierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: default avatarBard Liao <yung-chuan.liao@linux.intel.com>
Link: https://lore.kernel.org/r/20200817152923.3259-3-yung-chuan.liao@linux.intel.comSigned-off-by: default avatarVinod Koul <vkoul@kernel.org>
parent ebf878ed
......@@ -1434,6 +1434,12 @@ static int intel_suspend(struct device *dev)
return 0;
}
if (pm_runtime_suspended(dev)) {
dev_dbg(dev, "%s: pm_runtime status: suspended\n", __func__);
return 0;
}
ret = sdw_cdns_enable_interrupt(cdns, false);
if (ret < 0) {
dev_err(dev, "cannot disable interrupts on suspend\n");
......@@ -1494,6 +1500,16 @@ static int intel_resume(struct device *dev)
return 0;
}
if (pm_runtime_suspended(dev)) {
dev_dbg(dev, "%s: pm_runtime status was suspended, forcing active\n", __func__);
/* follow required sequence from runtime_pm.rst */
pm_runtime_disable(dev);
pm_runtime_set_active(dev);
pm_runtime_mark_last_busy(dev);
pm_runtime_enable(dev);
}
ret = intel_init(sdw);
if (ret) {
dev_err(dev, "%s failed: %d", __func__, ret);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment