Commit bbe89970 authored by Wolfram Sang's avatar Wolfram Sang Committed by Wolfram Sang

i2c: gpio: fault-injector: add incomplete_write_byte

Add another injector for an incomplete transfer. As mentioned in the
docs, this one is important to check bus recovery algorithms with it.
Otherwise random data may be sent to devices!
Signed-off-by: default avatarWolfram Sang <wsa+renesas@sang-engineering.com>
Signed-off-by: default avatarWolfram Sang <wsa@the-dreams.de>
parent 16d55daa
......@@ -60,3 +60,22 @@ above, the bus master under test should detect this condition and try a bus
recovery. This time, however, it should succeed and the device should release
SDA after toggling SCL.
"incomplete_write_byte"
-----------------------
Similar to above, this file is write only and you need to write the address of
an existing I2C client device to it.
The injector will again stop at one ACK phase, so the device will keep SDA low
because it acknowledges data. However, there are two differences compared to
'incomplete_address_phase':
a) the message sent out will be a write message
b) after the address byte, a 0x00 byte will be transferred. Then, stop at ACK.
This is a highly delicate state, the device is set up to write any data to
register 0x00 (if it has registers) when further clock pulses happen on SCL.
This is why bus recovery (up to 9 clock pulses) must either check SDA or send
additional STOP conditions to ensure the bus has been released. Otherwise
random data will be written to a device!
......@@ -143,6 +143,25 @@ static int fops_incomplete_addr_phase_set(void *data, u64 addr)
}
DEFINE_DEBUGFS_ATTRIBUTE(fops_incomplete_addr_phase, NULL, fops_incomplete_addr_phase_set, "%llu\n");
static int fops_incomplete_write_byte_set(void *data, u64 addr)
{
struct i2c_gpio_private_data *priv = data;
u32 pattern;
if (addr > 0x7f)
return -EINVAL;
/* ADDR (7 bit) + WR (1 bit) + Client ACK (1 bit) */
pattern = (addr << 2) | 1;
/* 0x00 (8 bit) + Client ACK, keep SDA hi (1 bit) */
pattern = (pattern << 9) | 1;
i2c_gpio_incomplete_transfer(priv, pattern, 18);
return 0;
}
DEFINE_DEBUGFS_ATTRIBUTE(fops_incomplete_write_byte, NULL, fops_incomplete_write_byte_set, "%llu\n");
static void i2c_gpio_fault_injector_init(struct platform_device *pdev)
{
struct i2c_gpio_private_data *priv = platform_get_drvdata(pdev);
......@@ -166,6 +185,8 @@ static void i2c_gpio_fault_injector_init(struct platform_device *pdev)
debugfs_create_file_unsafe("sda", 0600, priv->debug_dir, priv, &fops_sda);
debugfs_create_file_unsafe("incomplete_address_phase", 0200, priv->debug_dir,
priv, &fops_incomplete_addr_phase);
debugfs_create_file_unsafe("incomplete_write_byte", 0200, priv->debug_dir,
priv, &fops_incomplete_write_byte);
}
static void i2c_gpio_fault_injector_exit(struct platform_device *pdev)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment