net_sched: fix dequeuer fairness
Results on dummy device can be seen in my netconf 2011 slides. These results are for a 10Gige IXGBE intel nic - on another i5 machine, very similar specs to the one used in the netconf2011 results. It turns out - this is a hell lot worse than dummy and so this patch is even more beneficial for 10G. Test setup: ---------- System under test sending packets out. Additional box connected directly dropping packets. Installed prio qdisc on the eth device and default netdev default length of 1000 used as is. The 3 prio bands each were set to 100 (didnt factor in the results). 5 packet runs were made and the middle 3 picked. results ------- The "cpu" column indicates the which cpu the sample was taken on, The "Pkt runx" carries the number of packets a cpu dequeued when forced to be in the "dequeuer" role. The "avg" for each run is the number of times each cpu should be a "dequeuer" if the system was fair. 3.0-rc4 (plain) cpu Pkt run1 Pkt run2 Pkt run3 ================================================ cpu0 21853354 21598183 22199900 cpu1 431058 473476 393159 cpu2 481975 477529 458466 cpu3 23261406 23412299 22894315 avg 11506948 11490372 11486460 3.0-rc4 with patch and default weight 64 cpu Pkt run1 Pkt run2 Pkt run3 ================================================ cpu0 13205312 13109359 13132333 cpu1 10189914 10159127 10122270 cpu2 10213871 10124367 10168722 cpu3 13165760 13164767 13096705 avg 11693714 11639405 11630008 As you can see the system is still not perfect but is a lot better than what it was before... At the moment we use the old backlog weight, weight_p which is 64 packets. It seems to be reasonably fine with that value. The system could be made more fair if we reduce the weight_p (as per my presentation), but we are going to affect the shared backlog weight. Unless deemed necessary, I think the default value is fine. If not we could add yet another knob. Signed-off-by: Jamal Hadi Salim <jhs@mojatatu.com> Signed-off-by: David S. Miller <davem@davemloft.net>
Showing
Please register or sign in to comment