spi/pl022: remove dangling status check

Signed-off-by: Virupax Sadashivpetimath <virupax.sadashivpetimath@stericsson.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

drivers/spi/amba-pl022.c

@@ -1906,8 +1906,6 @@ static int pl022_setup(struct spi_device *spi)
 	    && ((pl022->master_info)->enable_dma)) {
 		chip->enable_dma = true;
 		dev_dbg(&spi->dev, "DMA mode set in controller state\n");
-		if (status < 0)
-			goto err_config_params;
 		SSP_WRITE_BITS(chip->dmacr, SSP_DMA_ENABLED,
 			       SSP_DMACR_MASK_RXDMAE, 0);
 		SSP_WRITE_BITS(chip->dmacr, SSP_DMA_ENABLED,