MIPS: Lantiq: Activate more drivers in default configuration

This activates the following functionalities:
* SMP support (used on xRX200)
* PCI support
* NAND driver
* PHY driver
* UART
* Watchdog
* USB 2.0 controller

These driver are driving different IP cores found on the supported SoCs.
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
Acked-by: John Crispin <john@phrozen.org>
Cc: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/14628/Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

arch/mips/configs/xway_defconfig

 CONFIG_LANTIQ=y
+CONFIG_PCI_LANTIQ=y
 CONFIG_XRX200_PHY_FW=y
 CONFIG_CPU_MIPS32_R2=y
+CONFIG_MIPS_MT_SMP=y
+CONFIG_MIPS_VPE_LOADER=y
 # CONFIG_COMPACTION is not set
+CONFIG_NR_CPUS=2
 CONFIG_HZ_100=y
 # CONFIG_SECCOMP is not set
 # CONFIG_LOCALVERSION_AUTO is not set
@@ -22,8 +26,8 @@ CONFIG_MODULE_UNLOAD=y
 # CONFIG_BLK_DEV_BSG is not set
 CONFIG_PARTITION_ADVANCED=y
 # CONFIG_IOSCHED_CFQ is not set
+CONFIG_PCI=y
 # CONFIG_COREDUMP is not set
-# CONFIG_SUSPEND is not set
 CONFIG_NET=y
 CONFIG_PACKET=y
 CONFIG_UNIX=y
@@ -81,6 +85,8 @@ CONFIG_MTD_COMPLEX_MAPPINGS=y
 CONFIG_MTD_PHYSMAP=y
 CONFIG_MTD_PHYSMAP_OF=y
 CONFIG_MTD_LANTIQ=y
+CONFIG_MTD_NAND=y
+CONFIG_MTD_NAND_XWAY=y
 CONFIG_EEPROM_93CX6=m
 CONFIG_SCSI=y
 CONFIG_BLK_DEV_SD=y
@@ -88,6 +94,7 @@ CONFIG_NETDEVICES=y
 CONFIG_LANTIQ_ETOP=y
 # CONFIG_NET_VENDOR_WIZNET is not set
 CONFIG_PHYLIB=y
+CONFIG_INTEL_XWAY_PHY=y
 CONFIG_PPP=m
 CONFIG_PPP_FILTER=y
 CONFIG_PPP_MULTILINK=y
@@ -108,17 +115,21 @@ CONFIG_SERIAL_8250=y
 CONFIG_SERIAL_8250_CONSOLE=y
 CONFIG_SERIAL_8250_RUNTIME_UARTS=2
 CONFIG_SERIAL_OF_PLATFORM=y
+CONFIG_SERIAL_LANTIQ=y
 CONFIG_SPI=y
 CONFIG_GPIO_MM_LANTIQ=y
 CONFIG_GPIO_STP_XWAY=y
 # CONFIG_HWMON is not set
 CONFIG_WATCHDOG=y
+CONFIG_LANTIQ_WDT=y
 # CONFIG_HID is not set
 # CONFIG_USB_HID is not set
 CONFIG_USB=y
 CONFIG_USB_ANNOUNCE_NEW_DEVICES=y
 CONFIG_USB_STORAGE=y
 CONFIG_USB_STORAGE_DEBUG=y
+CONFIG_USB_DWC2=y
+CONFIG_USB_DWC2_PCI=y
 CONFIG_NEW_LEDS=y
 CONFIG_LEDS_CLASS=y
 CONFIG_LEDS_TRIGGERS=y