Commit df48d3b5 authored by Jerome Brunet's avatar Jerome Brunet Committed by Marc Zyngier

dt-bindings: interrupt-controller: Add DT binding for meson GPIO interrupt controller

This commit adds the device tree bindings description for Amlogic's GPIO
interrupt controller available on the meson8b, gxbb and gxl SoC families

Cc: Heiner Kallweit <hkallweit1@gmail.com>
Acked-by: default avatarRob Herring <robh@kernel.org>
Signed-off-by: default avatarJerome Brunet <jbrunet@baylibre.com>
Signed-off-by: default avatarMarc Zyngier <marc.zyngier@arm.com>
parent 44c4c25e
Amlogic meson GPIO interrupt controller
Meson SoCs contains an interrupt controller which is able to watch the SoC
pads and generate an interrupt on edge or level. The controller is essentially
a 256 pads to 8 GIC interrupt multiplexer, with a filter block to select edge
or level and polarity. It does not expose all 256 mux inputs because the
documentation shows that the upper part is not mapped to any pad. The actual
number of interrupt exposed depends on the SoC.
Required properties:
- compatible : must have "amlogic,meson8-gpio-intc” and either
“amlogic,meson8b-gpio-intc” for meson8b SoCs (S805) or
“amlogic,meson-gxbb-gpio-intc” for GXBB SoCs (S905) or
“amlogic,meson-gxl-gpio-intc” for GXL SoCs (S905X, S912)
- interrupt-parent : a phandle to the GIC the interrupts are routed to.
Usually this is provided at the root level of the device tree as it is
common to most of the SoC.
- reg : Specifies base physical address and size of the registers.
- interrupt-controller : Identifies the node as an interrupt controller.
- #interrupt-cells : Specifies the number of cells needed to encode an
interrupt source. The value must be 2.
- meson,channel-interrupts: Array with the 8 upstream hwirq numbers. These
are the hwirqs used on the parent interrupt controller.
Example:
gpio_interrupt: interrupt-controller@9880 {
compatible = "amlogic,meson-gxbb-gpio-intc",
"amlogic,meson-gpio-intc";
reg = <0x0 0x9880 0x0 0x10>;
interrupt-controller;
#interrupt-cells = <2>;
meson,channel-interrupts = <64 65 66 67 68 69 70 71>;
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment