ARM: shmobile: lager: enable HS-USB

Enable HS-USB device for the Lager board, defining the GPIO that the driver
should check when probing. Since this board doesn't have the OTG ID pin, we
assume that GP5_18 (USB0_PWEN) is an ID pin because it is 1 when the SW5 is
in position 2-3 (meaning USB function) and 0 in other positions.

Note that there will be pinctrl-related error messages if both internal PCI
and HS-USB drivers are enabled but they should be just ignored.
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
[Sergei: added pin node and prop, moved device node, fixed summary, supplemented
changelog]
Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Signed-off-by: Simon Horman <horms+renesas@verge.net.au>

arch/arm/boot/dts/r8a7790-lager.dts

@@ -268,6 +268,11 @@ iic3_pins: iic3 {
 		renesas,function = "iic3";
 	};
 
+	hsusb_pins: hsusb {
+		renesas,groups = "usb0_ovc_vbus";
+		renesas,function = "usb0";
+	};
+
 	usb0_pins: usb0 {
 		renesas,groups = "usb0";
 		renesas,function = "usb0";
@@ -478,6 +483,13 @@ &pci2 {
 	pinctrl-names = "default";
 };
 
+&hsusb {
+	status = "okay";
+	pinctrl-0 = <&hsusb_pins>;
+	pinctrl-names = "default";
+	renesas,enable-gpio = <&gpio5 18 GPIO_ACTIVE_HIGH>;
+};
+
 &usbphy {
 	status = "okay";
 };