Commit e33a3f84 authored by Johan Hovold's avatar Johan Hovold Committed by Samuel Ortiz

NFC: nfcmrvl: allow gpio 0 for reset signalling

Allow gpio 0 to be used for reset signalling, and instead use negative
errnos to disable the reset functionality.
Signed-off-by: default avatarJohan Hovold <johan@kernel.org>
Signed-off-by: default avatarSamuel Ortiz <sameo@linux.intel.com>
parent 0d1ca88b
......@@ -123,12 +123,12 @@ struct nfcmrvl_private *nfcmrvl_nci_register_dev(enum nfcmrvl_phy phy,
memcpy(&priv->config, pdata, sizeof(*pdata));
if (priv->config.reset_n_io) {
if (gpio_is_valid(priv->config.reset_n_io)) {
rc = gpio_request_one(priv->config.reset_n_io,
GPIOF_OUT_INIT_LOW,
"nfcmrvl_reset_n");
if (rc < 0) {
priv->config.reset_n_io = 0;
priv->config.reset_n_io = -EINVAL;
nfc_err(dev, "failed to request reset_n io\n");
}
}
......@@ -183,7 +183,7 @@ struct nfcmrvl_private *nfcmrvl_nci_register_dev(enum nfcmrvl_phy phy,
error_free_dev:
nci_free_device(priv->ndev);
error_free_gpio:
if (priv->config.reset_n_io)
if (gpio_is_valid(priv->config.reset_n_io))
gpio_free(priv->config.reset_n_io);
kfree(priv);
return ERR_PTR(rc);
......@@ -199,7 +199,7 @@ void nfcmrvl_nci_unregister_dev(struct nfcmrvl_private *priv)
nfcmrvl_fw_dnld_deinit(priv);
if (priv->config.reset_n_io)
if (gpio_is_valid(priv->config.reset_n_io))
gpio_free(priv->config.reset_n_io);
nci_unregister_device(ndev);
......@@ -267,7 +267,6 @@ int nfcmrvl_parse_dt(struct device_node *node,
reset_n_io = of_get_named_gpio(node, "reset-n-io", 0);
if (reset_n_io < 0) {
pr_info("no reset-n-io config\n");
reset_n_io = 0;
} else if (!gpio_is_valid(reset_n_io)) {
pr_err("invalid reset-n-io GPIO\n");
return reset_n_io;
......
......@@ -23,7 +23,7 @@ struct nfcmrvl_platform_data {
*/
/* GPIO that is wired to RESET_N signal */
unsigned int reset_n_io;
int reset_n_io;
/* Tell if transport is muxed in HCI one */
unsigned int hci_muxed;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment