1. 20 Jun, 2017 7 commits
  2. 19 Jun, 2017 6 commits
    • Xin Long's avatar
      sctp: ensure ep is not destroyed before doing the dump · 86fdb344
      Xin Long authored
      Now before dumping a sock in sctp_diag, it only holds the sock while
      the ep may be already destroyed. It can cause a use-after-free panic
      when accessing ep->asocs.
      
      This patch is to set sctp_sk(sk)->ep NULL in sctp_endpoint_destroy,
      and check if this ep is already destroyed before dumping this ep.
      Suggested-by: default avatarMarcelo Ricardo Leitner <marcelo.leitner@gmail.com>
      Signed-off-by: default avatarXin Long <lucien.xin@gmail.com>
      Acked-by: default avatarNeil Horman <nhorman@tuxdrver.com>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      86fdb344
    • Lin Yun Sheng's avatar
      net/hns:bugfix of ethtool -t phy self_test · 7fe5b914
      Lin Yun Sheng authored
      This patch fixes the phy loopback self_test failed issue. when
      Marvell Phy Module is loaded, it will powerdown fiber when doing
      phy loopback self test, which cause phy loopback self_test fail.
      Signed-off-by: default avatarLin Yun Sheng <linyunsheng@huawei.com>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      7fe5b914
    • Gao Feng's avatar
      net: 8021q: Fix one possible panic caused by BUG_ON in free_netdev · 9745e362
      Gao Feng authored
      The register_vlan_device would invoke free_netdev directly, when
      register_vlan_dev failed. It would trigger the BUG_ON in free_netdev
      if the dev was already registered. In this case, the netdev would be
      freed in netdev_run_todo later.
      
      So add one condition check now. Only when dev is not registered, then
      free it directly.
      
      The following is the part coredump when netdev_upper_dev_link failed
      in register_vlan_dev. I removed the lines which are too long.
      
      [  411.237457] ------------[ cut here ]------------
      [  411.237458] kernel BUG at net/core/dev.c:7998!
      [  411.237484] invalid opcode: 0000 [#1] SMP
      [  411.237705]  [last unloaded: 8021q]
      [  411.237718] CPU: 1 PID: 12845 Comm: vconfig Tainted: G            E   4.12.0-rc5+ #6
      [  411.237737] Hardware name: VMware, Inc. VMware Virtual Platform/440BX Desktop Reference Platform, BIOS 6.00 07/02/2015
      [  411.237764] task: ffff9cbeb6685580 task.stack: ffffa7d2807d8000
      [  411.237782] RIP: 0010:free_netdev+0x116/0x120
      [  411.237794] RSP: 0018:ffffa7d2807dbdb0 EFLAGS: 00010297
      [  411.237808] RAX: 0000000000000002 RBX: ffff9cbeb6ba8fd8 RCX: 0000000000001878
      [  411.237826] RDX: 0000000000000001 RSI: 0000000000000282 RDI: 0000000000000000
      [  411.237844] RBP: ffffa7d2807dbdc8 R08: 0002986100029841 R09: 0002982100029801
      [  411.237861] R10: 0004000100029980 R11: 0004000100029980 R12: ffff9cbeb6ba9000
      [  411.238761] R13: ffff9cbeb6ba9060 R14: ffff9cbe60f1a000 R15: ffff9cbeb6ba9000
      [  411.239518] FS:  00007fb690d81700(0000) GS:ffff9cbebb640000(0000) knlGS:0000000000000000
      [  411.239949] CS:  0010 DS: 0000 ES: 0000 CR0: 0000000080050033
      [  411.240454] CR2: 00007f7115624000 CR3: 0000000077cdf000 CR4: 00000000003406e0
      [  411.240936] Call Trace:
      [  411.241462]  vlan_ioctl_handler+0x3f1/0x400 [8021q]
      [  411.241910]  sock_ioctl+0x18b/0x2c0
      [  411.242394]  do_vfs_ioctl+0xa1/0x5d0
      [  411.242853]  ? sock_alloc_file+0xa6/0x130
      [  411.243465]  SyS_ioctl+0x79/0x90
      [  411.243900]  entry_SYSCALL_64_fastpath+0x1e/0xa9
      [  411.244425] RIP: 0033:0x7fb69089a357
      [  411.244863] RSP: 002b:00007ffcd04e0fc8 EFLAGS: 00000202 ORIG_RAX: 0000000000000010
      [  411.245445] RAX: ffffffffffffffda RBX: 00007ffcd04e2884 RCX: 00007fb69089a357
      [  411.245903] RDX: 00007ffcd04e0fd0 RSI: 0000000000008983 RDI: 0000000000000003
      [  411.246527] RBP: 00007ffcd04e0fd0 R08: 0000000000000000 R09: 1999999999999999
      [  411.246976] R10: 000000000000053f R11: 0000000000000202 R12: 0000000000000004
      [  411.247414] R13: 00007ffcd04e1128 R14: 00007ffcd04e2888 R15: 0000000000000001
      [  411.249129] RIP: free_netdev+0x116/0x120 RSP: ffffa7d2807dbdb0
      Signed-off-by: default avatarGao Feng <gfree.wind@vip.163.com>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      9745e362
    • Raju Rangoju's avatar
      cxgb4: notify uP to route ctrlq compl to rdma rspq · dec6b331
      Raju Rangoju authored
      During the module initialisation there is a possible race
      (basically race between uld and lld) where neither the uld
      nor lld notifies the uP about where to route the ctrl queue
      completions. LLD skips notifying uP as the rdma queues were
      not created by then (will leave it to ULD to notify the uP).
      As the ULD comes up, it also skips notifying the uP as the
      flag FULL_INIT_DONE is not set yet (ULD assumes that the
      interface is not up yet).
      
      Consequently, this race between uld and lld leaves uP
      unnotified about where to send the ctrl queue completions
      to, leading to iwarp RI_RES WR failure.
      
      Here is the race:
      
      CPU 0                                   CPU1
      
      - allocates nic rx queus
      - t4_sge_alloc_ctrl_txq()
      (if rdma rsp queues exists,
      tell uP to route ctrl queue
      compl to rdma rspq)
                                      - acquires the mutex_lock
                                      - allocates rdma response queues
                                      - if FULL_INIT_DONE set,
                                        tell uP to route ctrl queue compl
                                        to rdma rspq
                                      - relinquishes mutex_lock
      - acquires the mutex_lock
      - enable_rx()
      - set FULL_INIT_DONE
      - relinquishes mutex_lock
      
      This patch fixes the above issue.
      
      Fixes: e7519f99('cxgb4: avoid enabling napi twice to the same queue')
      Signed-off-by: default avatarRaju Rangoju <rajur@chelsio.com>
      Acked-by: default avatarSteve Wise <swise@opengridcomputing.com>
      CC: Stable <stable@vger.kernel.org> # 4.9+
      Signed-off-by: default avatarGanesh Goudar <ganeshgr@chelsio.com>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      dec6b331
    • David S. Miller's avatar
      Merge tag 'mac80211-for-davem-2017-06-16' of... · 4b153ca9
      David S. Miller authored
      Merge tag 'mac80211-for-davem-2017-06-16' of git://git.kernel.org/pub/scm/linux/kernel/git/jberg/mac80211
      
      Johannes Berg says:
      
      ====================
      Here's just the fix for that ancient bug:
       * remove wext calling ndo_do_ioctl, since nobody needs
         that now and it makes the type change easier
       * use struct iwreq instead of struct ifreq almost everywhere
         in wireless extensions code
       * copy only struct iwreq from userspace in dev_ioctl for the
         wireless extensions, since it's smaller than struct ifreq
      ====================
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      4b153ca9
    • Haishuang Yan's avatar
      ip6_tunnel: Correct tos value in collect_md mode · 46f8cd9d
      Haishuang Yan authored
      Same as ip_gre, geneve and vxlan, use key->tos as traffic class value.
      
      CC: Peter Dawson <petedaws@gmail.com>
      Fixes: 0e9a7095 ("ip6_tunnel, ip6_gre: fix setting of DSCP on
      encapsulated packets”)
      Signed-off-by: default avatarHaishuang Yan <yanhaishuang@cmss.chinamobile.com>
      Acked-by: default avatarPeter Dawson <peter.a.dawson@boeing.com>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      46f8cd9d
  3. 16 Jun, 2017 4 commits
  4. 15 Jun, 2017 17 commits
  5. 14 Jun, 2017 6 commits