- 14 Jun, 2008 40 commits
-
-
Ron Rindjunsky authored
The patch removes 4965 prefix from iwl4965_ucode. Signed-off-by:
Ron Rindjunsky <ron.rindjunsky@intel.com> Signed-off-by:
Tomas Winkler <tomas.winkler@intel.com> Signed-off-by:
Zhu Yi <yi.zhu@intel.com> Signed-off-by:
John W. Linville <linville@tuxdriver.com>
-
Ester Kummer authored
This patch returns channel list to sysfs. Signed-off-by:
Ester Kummer <ester.kummer@intel.com> Signed-off-by:
-
Tomas Winkler authored
This patch fixes setting beacon interval 1. in register_hw it honors value requested by the driver 2. It uses default 100 instead of 1000 or 10000. Scanning for beacon interval ~1sec and above is not sane Signed-off-by:
Emmanuel Grumbach <emmanuel.grumbach@intel.com> Signed-off-by:
-
Robert P. J. Day authored
Signed-off-by:
Robert P. J. Day <rpjday@crashcourse.ca> Signed-off-by:
-
Jussi Kivilinna authored
Reduce amount of kmalloc/kfree calls in set/get_oid by preallocating command buffer. Signed-off-by:
Jussi Kivilinna <jussi.kivilinna@mbnet.fi> Signed-off-by:
-
Jussi Kivilinna authored
rndis_wlan used kmalloc to allocate private data structure and leaving data uninitialized, but later assumed to be set zero. Signed-off-by:
-
Ron Rindjunsky authored
This patch denies the use of framentation while ampdu is used. Signed-off-by:
Johannes Berg <johannes@sipsolutions.net> Signed-off-by:
-
Emmanuel Grumbach authored
This patch removes the iwlcore_low_level_notify. The notification chain is not required in this level. Signed-off-by:
-
Emmanuel Grumbach authored
This patch cleans up iwlwifi's code: Add missing include, remove empty lines etc... Signed-off-by:
-
Zhu Yi authored
The patch fixes the problem that software rf_kill messes up the card status when it is disabled if the interface is down. Signed-off-by:
-
Emmanuel Grumbach authored
This patch removes iwl4965_calc_db_from_ratio which is dead code. Signed-off-by:
-
Emmanuel Grumbach authored
This patch renames iwl4965_get_tempearture to iwl4965_hw_get_temperature and replaces usage of original iwl4965_hw_get_temperature by direct access to priv->temperature. Signed-off-by:
-
Emmanuel Grumbach authored
This patch moves iwl4965_rf_kill_ct_config to iwl-core.c. Signed-off-by:
-
Tomas Winkler authored
This patch 1. cleans up scanning code. 2. It adds round robin of TX antannas/chains. Signed-off-by:
-
Tomas Winkler authored
This patch moves rate helpers to iwlcore. Signed-off-by:
-
Tomas Winkler authored
This patch moves scan code to iwl-scan.c file in iwlcore module. Signed-off-by:
-
Emmanuel Grumbach authored
This patch adds a check for bad length in set key flow. This solves the Oops reported by Thomas Backlund, Joonwoo Park and Ian Schram. It also adds some debug printing that can be useful. Signed-off-by:
-
Tomas Winkler authored
This patch 1. Refactors settings of tx power 2. enables iwconfig txpower <value> 3. adds 5000 HW tx power Signed-off-by:
-
Tomas Winkler authored
This patch refactors tx aggregation respnse flow and fixes bug revealed by tx_info to cb patch Signed-off-by:
-
Assaf Krauss authored
This fix allows to move between modes (ad-hoc to managed, and vice versa). Since mode changes can only be done while driver is down, check for ibss support can only be made when the channel is set (afte the driver goes up). Signed-off-by:
Assaf Krauss <assaf.krauss@intel.com> Signed-off-by:
-
Assaf Krauss authored
This patch enables ibss mode. It consists of two changes upon entering ibss mode: 1. Removing the redundant line which clears the driver's station table. This line creates a discrepancy between the driver and the FW's station table. This prevented the generation of beacons. 2. Assigning a default value to priv's assoc_id. Normally given by an AP in STA mode, this field is used as an indication for association. Being 0, it prevented normal TX flow. 3. Remove a redundant ADD_STA command that cause uCode error. 4. Delay the set_mode until after the uCode is ready. Signed-off-by:
-
Emmanuel Grumbach authored
Clear STATUS_FW_ERROR in the _up_ flow before reseting NIC. UP flow will otherwise call restart again causing endless restart loop. Signed-off-by:
-
Mohamed Abbas authored
This patch fixes SW RF-kill. If we resumed from S3 state with SW RF-kill set, the driver wouldn't be able to remove SW RF-kill. This patch fixes this. Signed-off-by:
Mohamed Abbas <mabbas@linux.intel.com> Signed-off-by:
-
Tomas Winkler authored
This patch changes uCode log print to for easier parsing. Signed-off-by:
-
Emmanuel Grumbach authored
It is wrong to set the rxon channel according to the ht-channel in case there is a mismatch (e.g. when there is no ht). Signed-off-by:
Guy Cohen <guy.cohen@intel.com> Signed-off-by:
-
Emmanuel Grumbach authored
This patch removes redundant flags regarding to FAT channel. Use mac80211's flag instead. Signed-off-by:
-
Tomas Winkler authored
This patch removes IEEE80211_CHAN_W_RADAR_DETECT flag. Signed-off-by:
-
Ron Rindjunsky authored
This fix opens back the aggregation decision path for iwlwifi. Signed-off-by:
-
Ron Rindjunsky authored
This patch switches the use of internal iwlwifi structure with ieee80211_conf in order to examine ht rate capabilities. Signed-off-by:
-
Tomas Winkler authored
This patch adds TX aggregation handler for 5000 HW. Signed-off-by:
-
Ron Rindjunsky authored
This patch maps sw and hw queues (for aggregations), so the right mac80211 queue will be waken when ieee80211_wake_queue is invoked. Signed-off-by:
-
Emmanuel Grumbach authored
This patch adds the possibility to disable the tx_power calibration. In 5000 HW, this calibration is implemented in uCode, hence, it is disabled in driver by default. Signed-off-by:
-
Emmanuel Grumbach authored
This patch makes some clean up in setup/cancel_deferred_work. iwl_setup_deferred_work does the work that is common to 4965 and 5000, then it calls to HW specific handlers. This patch also removes uneeded work_struct from iwl_priv. Signed-off-by:
-
Emmanuel Grumbach authored
This patch removes the possibility not to compile the run time calibrations. It also renames priv->sensitivity_work to priv->run_time_calib_work, and moves bg_run_time_calib to iwl4965_base since it is common to both: 4965 and 5000. Signed-off-by:
-
Holger Schurig authored
Signed-off-by:
Holger Schurig <hs4233@mail.mn-solutions.de> Acked-by:
Dan Williams <dcbw@redhat.com> Signed-off-by:
-
Holger Schurig authored
Signed-off-by:
-
Holger Schurig authored
Signed-off-by:
-
Holger Schurig authored
This helps against lost interrupts and aids in debugging this. Signed-off-by:
-
Tony Vroon authored
Implement missing EU regulatory domain for mac80211. Based on the information in IEEE 802.11-2007 (specifically pages 1142, 1143 & 1148) and ETSI 301 893 (V1.4.1). With thanks to Johannes Berg. Signed-off-by:
Tony Vroon <tony@linx.net> Acked-by:
-
Michael Buesch authored
The comments ended up in the wrong place due to a merge error. Signed-off-by:
Michael Buesch <mb@bu3sch.de> Signed-off-by:
-
