into redhat.com:/spare/repo/net-drivers-2.6

into redhat.com:/spare/repo/net-drivers-2.6

into redhat.com:/spare/repo/net-drivers-2.6

into redhat.com:/spare/repo/net-drivers-2.6

into redhat.com:/spare/repo/net-drivers-2.6

into redhat.com:/spare/repo/net-drivers-2.6

into redhat.com:/spare/repo/net-drivers-2.6

From: Jeff Lightfoot <jeffml@pobox.com>

The following patch to net/sk98lin/skvpd.c was put together by Marc Bouget,
mbouget at club-internet.fr.

This patch works around a corrupt EEPROM (VPD?) in the ASUS K8V Deluxe SE
motherboard ethernet chipset and allows the network driver to work
correctly.  We have written to ASUS and the sk98lin maintainers but have
not heard anything back.

Joe Perches pointed out an error in patch 8.  As I looked at the results
closer 3 out of 4 looked correct.  This fixes the output for the last
case.  Output is now the same on IA32 and PPC64 hardware.

the Broadcom BCM4401 driver restores pci configuration on resume only when the 
device is up. On my notebook, this leads to a failure when the device is down 
during the S3 cycle. Short solution for now: Always restore pci config.

Also included are driver version update and change logs

Reduce scope of tx_lock

1) Provides support for new FarSync cards T1U, T2U, T4U and TE1
2) Provides support for an E1 interface
3) Provides support for a variant of X.21 that allows transmit and
receive clocks
4) Provide a raw socket interface directly to the data from the line.
5) Improves performance with less time in interrupts and more in BH's

This patch avoids a timeout when entering/exiting promiscuous mode with
tcpdump.  All pending xmit operations are flushed and if the queue is
full the timeout will occur.  The wake_queue avoids that timeout.
Tested ppc64 and ia32.

This patch corrects a printk when executed on a big-endian system.  Tested
ppc64.

The 79C973 version of the pcnet32 chipset would report all transmit
operations as being sent with a carrier error.  The root cause was
writing reserved bits in bcr33.  It caused the 973 to report xmit
as errors, and caused 975 and 976 to hard hang when reading bcr34.

My thanks to Bruce Penrod for his help in finding the cause of this
bug.

The current code will allow an infinite number of frames to be received
during one interrupt.  Tested ia32 and ppc64.

This removes the timer I recently added, and the 'ltint' interrupt
mitigation from the 79C971 and 79C972. It did not improve performance,
added complexity, and was a bad idea in hind sight.

This patch fixes a boundary condition.  It is possible to get an
interrupt and have the transmit queue completely full.  Without this
the driver will leak skb's and pci maps (if the arch supports them).

This patch correctly identifies the 79C976 as a PCnet/PRO not a FAST III.

This patch fixes a hard hang with 79C975 and 79C976 chip variants when
dumping BCR register #34.

This patch adds 'static' to two routines.  The prototype has static but
the instantiation did not.

 From:  Jean Delvare <khali@linux-fr.org>

 From:  Jean Delvare <khali@linux-fr.org>

Presently 2.6.6 backs out the CONFIG_8139_RXBUF_IDX in favor of using a
hardcoded 8139_RXBUF_IDX (again). This seems to have been done due to
some issues occuring with 8139_RXBUF_IDX =3D=3D 3, however (as the Kconfig
pointed out), we still need 8139_RXBUF_IDX =3D=3D 1 in the CONFIG_SH_DREAMC=
AST
case.

The patch which made this change can be seen at:

{MIME-mangled URL}

Before that, CONFIG_8139_RXBUF_IDX was set to 1 both in the
CONFIG_SH_DREAMCAST and CONFIG_EMBEDDED cases. This patch adds that
back into the current 8139too.

From: "J. Bruce Fields" <bfields@fieldses.org>
From: Neil Brown <neilb@cse.unsw.edu.au>

This fixes an oops on unmount (failure of the assertation at
fs/ext3/super.c:421).  Probably reproduceable just by creating and deleting a
single symlink over nfs and then unmounting the exported filesystem.

Recent change to fh_compose means dentry reference is *not* consumed, and so
usually has to be explicitly dput afterwards.  One usage was missed in that
patch, so this dput is needed.
Signed-off-by: Andrew Morton <akpm@osdl.org>

From: Andi Kleen <ak@suse.de>

Only the printk alone is not too useful, print the backtrace too.
Signed-off-by: Andrew Morton <akpm@osdl.org>

From: Pavel Machek <pavel@ucw.cz>
Signed-off-by: Andrew Morton <akpm@osdl.org>

From: Srivatsa Vaddagiri <vatsa@in.ibm.com>

Fix a CPU Hotplug problem wherein idle task's "->prio" value is not
restored to MAX_PRIO during CPU_DEAD handling.  Without this patch, once a
CPU is offlined and then later onlined, it becomes "more or less" useless
(does not run any task other than its idle task!)

Ingo said:

  The __setscheduler() call is (technically) incorrect because in the
  SCHED_NORMAL case the prio should be zero.  So it's a bit cleaner to set up
  the static priority to MAX_PRIO and then revert the policy to SCHED_NORMAL
  via __setscheduler().
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Andrew Morton <akpm@osdl.org>

From: "Randy.Dunlap" <rddunlap@osdl.org>

Remove the outdated "POSIX conformance testing by UNIFIX" message.

There is a general desire to reduce the quantity of noisy and/or
outdated kernel boot-time messages...

Suggested by Andi Kleen.

Ulrich's (old) comments:
http://www.nsa.gov/selinux/list-archive/0107/0525.cfm

Certifying Linux (Linux Journal):
http://www.linuxjournal.com/article.php?sid=0131

Agreed by Tim Bird, no dissenters that I heard of:
http://marc.theaimsgroup.com/?l=linux-kernel&m=108362954024749&w=2Signed-off-by: Andrew Morton <akpm@osdl.org>

drivers/char/watchdog/wdt.c: In function `wdt_init':
drivers/char/watchdog/wdt.c:638: warning: label `outrbt' defined but not used
Signed-off-by: Andrew Morton <akpm@osdl.org>