- 21 Oct, 2016 40 commits
-
-
Sakari Ailus authored
The media bus code obtained for try format may have been a code that the sensor did not even support. Use a supported code with the current pixel order. Signed-off-by:
Sakari Ailus <sakari.ailus@linux.intel.com> Reviewed-by:
Sebastian Reichel <sre@kernel.org> Signed-off-by:
Mauro Carvalho Chehab <mchehab@s-opensource.com>
-
Sakari Ailus authored
The code probably has been unindented at some point but rewrapping has not been done. Do it now. Also remove a useless memory allocation failure message. Signed-off-by:
-
Sakari Ailus authored
Provide more debugging information on reading the frame layout. Signed-off-by:
-
Sakari Ailus authored
Besides the image data, SMIA++ compliant sensors also provide embedded data in form of registers used to capture the image. Store this information for later use in frame descriptor and routing. Signed-off-by:
-
Sakari Ailus authored
Replace plain value 2 with SMIAPP_PADS when referring to the number of pads. Signed-off-by:
-
Sakari Ailus authored
The initialisation of the source sub-device is somewhat different as it's not created by the smiapp driver itself. Remove redundancy in initialising the two kind of sub-devices. Signed-off-by:
-
Sakari Ailus authored
The information gathered during frame format reading will be required earlier in the initialisation when it was available. Also return an error if frame format cannot be obtained. Signed-off-by:
-
Sakari Ailus authored
The smiapp_probe() is the sole caller of smiapp_init(). Unify the two. Signed-off-by:
-
Sakari Ailus authored
If the registered() callback failed, resources were left unaccounted for. Fix this, as well as add unregistering the sub-devices in driver unregistered() callback. Signed-off-by:
-
Sakari Ailus authored
Initialise the sensor in probe. The reason why it wasn't previously done in case of platform data was that the probe() of the driver that provided the clock through the set_xclk() callback would need to finish before the probe() function of the smiapp driver. The set_xclk() callback no longer exists. Signed-off-by:
-
Sakari Ailus authored
Instead, calculate how much is needed and then allocate the memory dynamically. Signed-off-by:
-
Sakari Ailus authored
The same pixel array size is required for the active format of each sub-device sink pad and try format of each sink pad of each opened file handle as well as for the native size rectangle. Signed-off-by:
-
Sakari Ailus authored
Remove the loop in sub-device registration and create each sub-device explicitly instead. Signed-off-by:
-
Sakari Ailus authored
This allows determining the number of pads in the entity based on the sensor. Signed-off-by:
-
Sakari Ailus authored
Define the number of pads explicitly in initialising the sub-devices. Signed-off-by:
-
Sakari Ailus authored
Simplify smiapp_init() by moving the initialisation of individual sub-devices to a separate function. Signed-off-by:
-
Hans Verkuil authored
Fix smatch error: media-git/drivers/media/platform/mtk-mdp/mtk_mdp_vpu.c:100 mtk_mdp_vpu_send_msg() error: double unlock 'mutex:&ctx->mdp_dev->vpulock' Signed-off-by:
Hans Verkuil <hans.verkuil@cisco.com> Signed-off-by:
-
Hans Verkuil authored
Improve the MT21C documentation, making it clearer that this format requires the MDP for further processing. Also fix the fourcc (it was a fivecc :-) ) Signed-off-by:
-
Minghsiu Tsai authored
This patch fix build error without CONFIG_PM_RUNTIME and CONFIG_PM_SLEEP Signed-off-by:
Minghsiu Tsai <minghsiu.tsai@mediatek.com> Signed-off-by:
-
Minghsiu Tsai authored
This patch fix build warning in arch x86 Signed-off-by:
-
Minghsiu Tsai authored
Add Minghsiu Tsai, Houlong Wei and Andrew-CT Chen as maintainers for Mediatek MDP driver Signed-off-by:
Houlong Wei <houlong.wei@mediatek.com> Signed-off-by:
Andrew-CT Chen <andrew-ct.chen@mediatek.com> Signed-off-by:
-
Minghsiu Tsai authored
Add V4L2_PIX_FMT_MT21C in format list. [mchehab@s-opensource.org: re-add mtk_mdp_size_align] Signed-off-by:
-
Mauro Carvalho Chehab authored
The mtk_mdp_dbg() is empty if !DEBUG. This causes the following warnings: drivers/media/platform/mtk-mdp/mtk_mdp_m2m.c: In function ‘mtk_mdp_try_fmt_mplane’: drivers/media/platform/mtk-mdp/mtk_mdp_m2m.c:231:52: warning: suggest braces around empty body in an ‘if’ statement [-Wempty-body] org_w, org_h, pix_mp->width, pix_mp->height); ^ drivers/media/platform/mtk-mdp/mtk_mdp_m2m.c: In function ‘mtk_mdp_m2m_start_streaming’: drivers/media/platform/mtk-mdp/mtk_mdp_m2m.c:414:21: warning: suggest braces around empty body in an ‘if’ statement [-Wempty-body] ctx->id, ret); ^ With could actually make the code to do something wrong. So, add an empty block to make it be parsed ok. Signed-off-by: -
Minghsiu Tsai authored
Add MDP node for MT8173 Signed-off-by:
-
Minghsiu Tsai authored
Add MDP driver for MT8173 Signed-off-by:
-
Minghsiu Tsai authored
Add a DT binding documentation of MDP for the MT8173 SoC from Mediatek Signed-off-by:
Rob Herring <robh@kernel.org> Signed-off-by:
-
Minghsiu Tsai authored
VPU driver add mdp support [mchehab@s-opensource.com: fix a merge conflict and make checkpatch happy] Signed-off-by:
-
Tiffany Lin authored
Add video decoder node for MT8173 Signed-off-by:
Tiffany Lin <tiffany.lin@mediatek.com> Signed-off-by:
-
Tiffany Lin authored
Add V4L2_PIX_FMT_MT21C support Signed-off-by:
-
Tiffany Lin authored
Add V4L2_PIX_FMT_MT21C documentation Signed-off-by:
-
Tiffany Lin authored
Add V4L2_PIX_FMT_MT21C format used on MT8173 driver. It is compressed format and need MT8173 MDP driver to transfer to other standard format. Signed-off-by:
-
Colin Ian King authored
pdev is being null checked, however, prior to that it is being dereferenced by platform_get_drvdata. Move the assignments of vpu and run to after the pdev null check to avoid a potential null pointer dereference. Signed-off-by:
Colin Ian King <colin.king@canonical.com> Reviewed-by:
-
Tiffany Lin authored
Add Tiffany Lin and Andrew-CT Chen as maintainers for Mediatek MT8173 vcodec drivers Signed-off-by:
-
Julia Lawall authored
PTR_ERR should access the value just tested by IS_ERR Generated by: scripts/coccinelle/tests/odd_ptr_err.cocci CC: Tiffany Lin <tiffany.lin@mediatek.com> Signed-off-by:
Julia Lawall <julia.lawall@lip6.fr> Signed-off-by:
Fengguang Wu <fengguang.wu@intel.com> Signed-off-by:
-
Tiffany Lin authored
Add vp9 decoder driver for MT8173 [mchehab@s-opensource.org: make checkpatch.pl happy] Signed-off-by:
-
Tiffany Lin authored
Add documentation for V4L2_PIX_FMT_VP9. Signed-off-by:
Wu-Cheng Li <wuchengli@chromium.org> Signed-off-by:
-
Wu-Cheng Li authored
VP9 is a video coding format and a successor to VP8. Signed-off-by:
-
Wu-Cheng Li authored
This adds VP9 video coding format, a successor to VP8. Signed-off-by:
-
Tiffany Lin authored
Add vp8 decoder driver for MT8173 [mchehab@s-opensource.org: make checkpatch.pl happy] Signed-off-by:
PC Chen <pc.chen@mediatek.com> Signed-off-by:
-
Tiffany Lin authored
Add h264 decoder driver for MT8173 Signed-off-by:
-
