From: Zwane Mwaikambo <zwane@holomorphy.com>

This patch makes us bail out in case we may have an interrupt which couldn't
be associated with an interrupt controller.  Without this we allow
unconfigured interrupts to be assigned and then later on we get "unexpected
IRQ trap at vector xx" during the ack phase.

scenario: This can occur if we fail irq setup during setup_IO_APIC_irqs for
some reason or other and then miss getting assigned a vector.  Later on we
then get assigned no_irq_type as our handler.

Patch for i386 and x86_64

From: Steven Rostedt <rostedt@goodmis.org>

The n_tty driver is missing some put_user checks.

- jiffies signedness fix

- Fix compile warning

From: Stephen Hemminger <shemminger@osdl.org>

The CPU frequency change detection code can change the values used to compute
time of day with TSC; but there was no locking around it.

From: Tim Schmielau <tim@physik3.uni-rostock.de>

Fixes the problem wherein nanosleep() is sleeping for the wrong duration.

When starting out with timer_jiffies=0, the timer cascade is (unneccessarily)
triggered on the first timer interrupt, incrementing all the higher indices.
When starting with any other initial jiffies value, we miss that and end up
with all higher indices being off by one.

From: William Lee Irwin III <wli@holomorphy.com>

The NMI watchdog has two different "modes": NMI_IO_APIC, which delivers NMI's
through the IO-APIC, and NMI_LOCAL_APIC, which uses the local APIC vector
table (LVT) to deliver the periodic NMI's.

Only NMI_IO_APIC requires being able to set up the PIT so it can deliver
NMI's through the IO-APIC, and so NMI_LOCAL_APIC has no dependency on the
timer being set up through the IO-APIC and is unjustifiably disabled by
check_timer() when the PIT cannot deliver interrupts through the IO-APIC.

This is important because one of the most important uses of NMI_LOCAL_APIC is
to get the NMI watchdog going when NMI_IO_APIC doesn't work.

So what this patch does to repair the situation is instead of checking to see
if the NMI watchdog is enabled at all, it instead checks whether the NMI
watchdog is being used in NMI_IO_APIC mode when a failure to set up the NMI
timer interrupt through the IO-APIC occurs.

The current nanosleep implementation has a signedness problem which can cause
it to sleep for 0x7ffffffe jiffies if a clock interrupt happens at the wrong
time.

The patch fixes that up, and also fixes an wrapping-unsafe 64-bit time
comparison.  Also uninline tstojiffie(), which has three call sites.

into home.transmeta.com:/home/torvalds/v2.5/linux

into home.transmeta.com:/home/torvalds/v2.5/linux

happens exactly on the sysenter entry path before the kernel stacks
have been switched to the proper ones.

Also, bump version to 1.5.

Leak fix contributed by Don Fry @ IBM

into redhat.com:/garz/repo/net-drivers-2.5

* Previous patch wiped NAPI support, adding it back here.  But,
  with a twist: this one doesn't disable/enable interrupts each
  time we enter/leave polling.  (It's EXPERIMENTAL).

* Corrected indentation from previous patches

* Fixed controller wake-up through ASF

* Added Interrupt Throttle Rate tuning support

* Added method to flush Tx FIFO after link disconnect; the hardware
  hangs on to Tx skb's that were in flight prior to link loss

* Miscellaneous whitespace changes

* Changed "Compaq" branding to "HP"

* Optimized E1000_*_REG macros

* Completely clean Tx descriptor to avoid potential dirty descriptor
  fetching (rare, but possible)

* ISR cleanup; performing single PCI read

* Removed modulus math; decreases CPU utilization, especially on PPC64
  [anton@samba.org]

* Added MII support

* Added support for 82541 and 82547 gigabit ethernet adapters

* Fixed IRQ registration bug; IRQ now registered after resources are
  acquired

* Setting speed/duplex is now it's own routine
* Update ETHTOOL_GEEPROM routine to use new eeprom size variable

* Version, copyright, changelog and MAINTAINERS updates

* Documentation/networking/e1000.txt updates

This is the patch to support NEC PC-9800 subarchitecture
against 2.5.65-ac1. (9/14)

C-bus(PC98's legacy bus like ISA) network cards support.
Change IO port and IRQ assign.
Add NE2000 compatible driver for PC-9800.
  PCI netwwork card works fine without patch.

Regards,
Osamu Tomita

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Check if ASF is enabled in EEPROM, and if so, enable
  PME wakeup when suspending.

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Bug fix: read wrong byte in EEPROM when offset is odd number
* Bug fix: memory leak in ETHTOOL_GSTRINGS
  [Oleg Drokin <green@linuxhacker.ru]

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Validate updates to MAC address as valid ethernet address.

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Bug fix on e100_close when repeating hot remove/hot add
  from team.  Basically need to disable interurpts and
  unregister handler before shutting h/w down.
* Need to mask only the relevant bits in the interrupt
  status register

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Honor WOL settings in EEPROM: only advertise WOL magic
  packet if in EEPROM.

On Thu, 20 Mar 2003, Scott Feldman wrote:


* ICH5 support: chipset integrated LAN (8255x)
* PHY loopback diags is broken on all ICHs

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Bug fix when changing to non-autoneg, device may lose
  link with some switches, so try to recover link by
  forcing PHY.

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Get rid of all of the strong marketing brand strings
  and replace with simple pci_device_id table.  pci.ids
  should be the master list for device ID/strings.

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Bug fix on setting up Tx csum

On Thu, 20 Mar 2003, Scott Feldman wrote:


* clean up #includes