This is the preliminary version with no error indications or
control over the types of failures.

From: Andries Brouwer <aebr@win.tue.nl>

I see an Oops in the SCSI code, caused by the fact that sdkp is NULL
in sd_shutdown. "How can that be?", you will ask - dev->driver_data was set
in sd_probe. But in my case sd_probe never finished. An insmod usb-storage
hangs forever, or at least for more than six hours, giving ample opportunity
to observe this race between sd_probe and sd_shutdown.
(Of course sd_probe hangs in sd_revalidate disk.)

Perhaps the obvious test is a good idea.
Locking seems meaningless - sd_probe will never finish.

This patch against scsi-misc-2.5 adds a sysfs attribute to allow scanning
(or rescanning) and deletion of scsi_devices.

It also allows scanning of entire hosts, channels, or targets.

It adds a per-host scan attribute, and a per scsi_device delete attribute.

This was in scsi_sysfs.c previously but given that it's not
sysfs-related and the whole scsi code is built around the driver
model now it's better to have it where it belongs.  Also allows
us to reduce the scsi_mod-wide globals.

DEV_STALE_* is used for some crude hacks in pcmcia netdrivers and it
seems people copied it blindly over to the scsi ones also it couldn't
ever be triggered (dev_link_t.open is never incremented e.g.)

The recent update made it check the scsi_remove_host retval which
is void now.

From: Jes Sorensen <jes@wildopensource.com>
with minor compile and rejection fixes

This patch might make the qla1280 driver build again in Linus' bk
tree. I don't have those sources here so I made the changes relative to
2.6.0-test2 and I am out of space on my laptop

Only compile tested, but if it works it works ;-)

CLONE_THREAD without CLONE_DETACHED will now return -EINVAL, and
for a while we will warn about anything that uses it (there are no
known users, but this will help pinpoint any problems if somebody
used to care about the invalid combination).

A part of the 64 bit kdev_t patch already got merged, and it changes the
format of /sys/block/<dev>/dev from %02x%02x to %u:%u.  The partition
could must also be changed.

e.g. cat /sys/block/hda/hda5/dev should return 3:5 instead of 0305

It was caused by improper IV calculation in loop.c

cryptoloop won't oops anymore if ECB mode is requested.

Just call them from the x86-64 entry code.

Also implement the x86-64 specific sys32_timer_create.

Add 32bit->64bit conversion functions for POSIX timers.

I kept timer_create architecture specific, because it does signal specific
stuff which is not portable enough for generic compat.

Add compat_sys_utimes for 32bit->64bit utimes conversion

Add compat_* functions for statfs64. The 32bit layout unfortunately
does not match x86-64.

This patch allows modules to work for ARM, and is the one thing which
prevents the standard tree from building for any ARM machine.

After reviewing the /proc/kcore and kclist issues, I've decided that I'm
no longer prepared to even _think_ about supporting /proc/kcore on ARM -
it just gets too ugly, and adds too much code to make it worth the effort,
the time or the energy to implement a solution to that problem.

/proc/kcore should probably go away, but in the meantime this just allows
ARM to ignore the issues.

makes 2.4->2.6 diff noticeable smaller

and add stripped down buffer_head variant (struct idetape_bh).

ide-tape is accessed by a char device (not a block one!),
it uses block layer only to queue requests.

also add missing Kconfig help entry from 2.4.x

- more locking fixes
- preserve gendev.parent of the old hwif in the new one

Noticed by Andries.Brouwer@cwi.nl.

Also:
- kill probe_lba_addressing() wrapper
- rename hwif->addressing to hwif->no_lba48

From Andries.Brouwer@cwi.nl.

- always use drive->capacity48 and kill drive->capacity

I've changed drive->capacity48 to drive->capacity64 to avoid confusion.

From Andries.Brouwer@cwi.nl.

- kill redundant, never executed code in lba_capacity_is_ok()
- add idedisk_supports_{hpa,lba48}() helpers
- don't recalculate drive->cyl for drives using LBA addressing,
  we never fall-back to CHS, so its useless and confusing
- remove wrong drive->head and drive->sect assignments for LBA-48
- don't overwrite id->lba_capacity and id->lba_capacity_2

HDIO_GETGEO_BIG_RAW is an ide specific hack introduced in 2.3.99-pre3.
There are no known programs using this ioctl.

Its aim was to provide current CHS translation to the user-space,
but very often it provides what driver thinks is a current translation
(drive with LBA have to support only one physical translation, also
 drive may not support chosen translation and there is no return value check).

hdparm -I can be used instead, it provides correct information
(and bogus data is still accessible through /proc/ide/hdX/geometry).

into home.osdl.org:/home/torvalds/v2.5/linux

into jen.americas.sgi.com:/src/lord/bitkeeper/xfs-2.5

by moving blk queue manipulation down into pagebuf. 
Fix some busted comments in page_buf.h, use a more
descriptive name for __pagebuf_iorequest.

SGI Modid: 2.5.x-xfs:slinx:155788a

The help for CONFIG_DEVPTS_FS claims that devfs "is a more general
facility".  But that apparently hasn't been true since 2.5.68.  This patch
removes that claim, and adds a warning to the DEVFS_FS help.

into home.osdl.org:/home/torvalds/v2.5/linux

into kernel.bkbits.net:/home/lord/xfs-2.5

From A1tmblwd@netscape.net

This updates my email address.

This corrects the following problem:

- release user buffer mapping early in read path (prevent oops in some
  HBA drivers)

Patch by Ivan Gyurdiev.

Here are some minor updates to the IPMI driver.  They fix the following:

    * A missing check for copy_to_user() in the watchdog driver.
    * Removal of unnecessary check_region() calls.
    * Fixes for the ACPI configuration. The previous one would only work
      with memory addresses, this will work with memory addresses,
      ports, and hadle checking that the type is correct.

The HPT366 code is broken - it tries to set the interface to too high a
speed, which leads to error messages at boot time and/or to data
corruption.

The typical effect at boot time is

 hde: set_drive_speed_status: status=0x51 { DriveReady SeekComplete Error }
 hde: set_drive_speed_status: error=0x04 { DriveStatusError }

Fixed thus.

When a socket has a request ready it notifies a server thread.
When the thread has 'received' the request it calls svc_sock_received
to confirm the fact.

In some cases, svc_sock_received would be called an extra time and
this could lead to linked-list corruption and bad problems.

raid5 tries to honour RWA_MASK, but messes it up and can return bad data.
Just ignore RAW_MASK for now.

Without these changes an x86-64 NUMA kernel won't boot in many
configurations.

The main change is the improved IOMMU code which supports merging of
mappings and has various bugfixes.

 - Update defconfig
 - Use argument ptregs in 32bit elf_core_copy_task_fpregs
 - Harden aperture fixup code: read aperture from the AGP bridge if needed,
   better error checking.
 - Support nmi_watchdog=panic to panic on watchdog trigger
 - IOMMU: Support panic on IOMMU overflow (iommu=panic)
 - IOMMU: Force SAC for mappings >40bits when iommu=force is active
   (this can potentially give better performance)
 - IOMMU: Cache northbridges for faster TLB flush
 - IOMMU: Fix SMP race in TLB flush
 - IOMMU: Merge pci_alloc_consistent and pci_map_single
 - IOMMU: Clean up leak tracing
 - IOMMU: Rewrite pci_map_sg, support merging of mappings
   On overflow fall back to piece-by-piece mapping.
 - IOMMU: Tell block layer to assume merging when iommu force is active
   (this gives better performance with MTP fusion, drawback is that the
   overflow/fragmentation handling of the IOMMU area is still a big
   dubious with that)
 - Fix/clean up per cpu data
 - Add 64bit clean time(2)
 - Export cpu_callout_map for IPv6
 - Handle nodes with no own memory in NUMA discovery.
   This fixes boot on various newer Opteron motherboards where the memory
   is only connected to a single CPU.
 - Fix fallback path for failed NUMA discovery. numnodes has to be reset.
 - Check for enabled nodes in NUMA discovery (Eric Biederman)
 - Remove NUMA emunodes support. Has badly bitrotted.
 - Add __clear_bit_string for IOMMU code
 - Add new 32bit system calls to ia32_unistd.h
 - Remove duplicate default_do_nmi prototype
 - Make PCI_DMA_BUS_IS_PHYS dependent on no_iommu
 - Fix padding length of siginfo_t to match glibc
 - More pci direct access functions.