- 02 May, 2019 6 commits
-
-
YueHaibing authored
Fixes gcc '-Wunused-but-set-variable' warning: sound/soc/codecs/tlv320aic32x4.c: In function 'aic32x4_setup_clocks': sound/soc/codecs/tlv320aic32x4.c:669:16: warning: variable 'mclk_rate' set but not used [-Wunused-but-set-variable] It is not used since introduction in commit 96c3bb00 ("ASoC: tlv320aic32x4: Dynamically Determine Clocking") Signed-off-by:
YueHaibing <yuehaibing@huawei.com> Signed-off-by:
Mark Brown <broonie@kernel.org>
-
YueHaibing authored
Fixes gcc '-Wunused-but-set-variable' warning: sound/soc/fsl/fsl_micfil.c: In function 'get_clk_div': sound/soc/fsl/fsl_micfil.c:154:6: warning: variable 'osr' set but not used [-Wunused-but-set-variable] It is never used since introduction in commit 47a70e6f ("ASoC: Add MICFIL SoC Digital Audio Interface driver.") Signed-off-by:
-
Peter Ujfalusi authored
The 24-bit TDM mode also applies to DSP_A and DSP_B modes. Most dais on the SoC side can not interpret I2S/Left_j with other than 2 channels of audio. Signed-off-by:
Peter Ujfalusi <peter.ujfalusi@ti.com> Signed-off-by:
-
Agrawal, Akshu authored
With CCF support in da7219, we can now set the correct rate of wclk and bclk. Signed-off-by:
Akshu Agrawal <akshu.agrawal@amd.com> Signed-off-by:
-
YueHaibing authored
During randconfig builds, I occasionally run into an invalid configuration WARNING: unmet direct dependencies detected for SND_SOC_TS3A227E Depends on [m]: SOUND [=y] && !UML && SND [=y] && SND_SOC [=y] && I2C [=m] Selected by [y]: - SND_SOC_MT8183_MT6358_TS3A227E_MAX98357A [=y] && SOUND [=y] && !UML && SND [=y] && SND_SOC [=y] && SND_SOC_MT8183 [=y] sound/soc/codecs/ts3a227e.o: In function `ts3a227e_i2c_probe': ts3a227e.c:(.text+0x684): undefined reference to `__devm_regmap_init_i2c' sound/soc/codecs/ts3a227e.o: In function `ts3a227e_driver_init': ts3a227e.c:(.init.text+0x18): undefined reference to `i2c_register_driver' sound/soc/codecs/ts3a227e.o: In function `ts3a227e_driver_exit': ts3a227e.c:(.exit.text+0x14): undefined reference to `i2c_del_driver' This patch add I2C dependency to fix this. Reported-by:
Hulk Robot <hulkci@huawei.com> Fixes: ebbddc75 ("ASoC: Mediatek: MT8183: Add machine driver with DA7219") Signed-off-by:
-
Colin Ian King authored
There is a spelling mistake in a dev_err message. Fix it. Signed-off-by:
Colin Ian King <colin.king@canonical.com> Signed-off-by:
-
- 27 Apr, 2019 34 commits
-
-
Pierre-Louis Bossart authored
SOF can only support specific machine drivers, handle dependencies Signed-off-by:
Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com> Reviewed-by:
Takashi Iwai <tiwai@suse.de> Signed-off-by:
-
Liam Girdwood authored
BDW uses hard coded IPC calls to set SSP, not needed in SOF as SSP is configured via topology. Signed-off-by:
Liam Girdwood <liam.r.girdwood@linux.intel.com> Signed-off-by:
-
Liam Girdwood authored
Build SOF core and Intel-specific drivers. Signed-off-by:
-
Pierre-Louis Bossart authored
Both drivers rely on the same module, expose it for both configurations Signed-off-by:
-
Liam Girdwood authored
Add platform differentiation operations for different Intel HDA DSP platforms. Signed-off-by:
Keyon Jie <yang.jie@linux.intel.com> Signed-off-by:
-
Keyon Jie authored
Add declarations for DAIs and utilities for link DMA management Signed-off-by:
-
Pierre-Louis Bossart authored
Add probe, init and cleanup routines for HDaudio. Signed-off-by:
-
Liam Girdwood authored
Add trace operations for Intel based HDA DSPs Signed-off-by:
-
Liam Girdwood authored
Add support or HDA DSP stream operations for Intel HDA DSPs. Signed-off-by:
-
Keyon Jie authored
Use hdac_io_ops and configure all required spin_locks/mutex to use hdac_hda_ext library. Keep the code conditional so that the HDA link and audio codec support can be removed. Signed-off-by:
-
Liam Girdwood authored
Add PCM operations for Intel HDA based DSPs. Signed-off-by:
-
Liam Girdwood authored
Add support for loading DSP firmware on Intel HDA based platforms. Signed-off-by:
-
Liam Girdwood authored
Add support for PCI based DSP devices. Signed-off-by:
-
Liam Girdwood authored
Add support ACPI based SOF DSP devices. Signed-off-by:
-
Liam Girdwood authored
Add HDA specific IPC mechanism for Intel DSP HW. Signed-off-by:
-
Liam Girdwood authored
Add support for various PM and core reset/run state transitions. Signed-off-by:
-
Liam Girdwood authored
Support HDA controller operations for DSP and provide space for future DSP HDA FW integration. Signed-off-by:
-
Liam Girdwood authored
Add SOF hardware DSP support for Intel Apollolake and Cannonlake based devices. Signed-off-by:
-
Guennadi Liakhovetski authored
Add IPC support required for devices introduced before Skylake (Merrifield, baytrail, CherryTrail, Haswell, Broadwell) Signed-off-by:
Guennadi Liakhovetski <guennadi.liakhovetski@linux.intel.com> Signed-off-by:
-
Liam Girdwood authored
Add SOF support for Intel Broadwell based devices. Signed-off-by:
Rander Wang <rander.wang@linux.intel.com> Signed-off-by:
Pan Xiuli <xiuli.pan@linux.intel.com> Signed-off-by:
-
Liam Girdwood authored
Add support for the audio DSP hardware found on Intel Baytrail, Cherrytrail and Braswell based devices. Signed-off-by:
-
Pierre-Louis Bossart authored
Helpers to set-up back-ends, create platform devices and common IO/block read/write operations Signed-off-by:
-
Pierre-Louis Bossart authored
Add common directory for xtensa architecture Signed-off-by:
-
Liam Girdwood authored
Add a simple "fallback" machine driver that can be used to enable SOF on boards with no codec device. This machine driver can also be forced for debug/development. Signed-off-by:
-
Liam Girdwood authored
Add support for saving and restoring DSP context in D3 to host DDR. The suspend callback includes: suspend all pcm's stream that are running, send CTX_SAVE ipc, drop all ipc's, release trace dma and then power off the DSP. And the resume callback performs the following steps: load FW, run FW, re-initialize trace, restore pipeline, restore the kcontrol values and finally send the ctx restore ipc to the dsp. The streams that are suspended are resumed by the ALSA resume trigger. If the streams are paused during system suspend, they are marked explicitly so they can be restored during PAUSE_RELEASE. Signed-off-by:
Ranjani Sridharan <ranjani.sridharan@linux.intel.com> Signed-off-by:
-
Liam Girdwood authored
Add userspace ABI for audio userspace application IO outside of regular ALSA PCM and kcontrols. This is intended to be used to format coefficients and data for custom processing components. Signed-off-by:
-
Liam Girdwood authored
The firmware loader exports APIs that can be called by core to load and process multiple different file formats. Signed-off-by:
-
Liam Girdwood authored
Add operation pointers that can be called by core to control a wide variety of DSP targets. The DSP HW drivers will fill in these operations. Signed-off-by:
-
Liam Girdwood authored
This patch adds support for real-time DSP logging (timestamped events and bespoke binary data) for firmware debug. The current solution relies on DMA transfers to system memory that is then accessed by userspace tools such as sof-logger. For Intel platforms, two types of DMAs are currently used (GP-DMA for Baytrail/CherryTrail and HDaudio DMA for SKL+) Due to historical reasons, the driver code follows the DSP firmware conventions and refers to 'traces', but it is currently unrelated to the Linux trace subsystem. Future solutions will include support for more advanced hardware (e.g. MIPI Sys-T), additional formats and the ability to enable/disable specific traces dynamically. Signed-off-by:
-
Liam Girdwood authored
SOF uses topology to define the DAPM graphs and widgets, DAIs, PCMs and set parameters for init and run time usage. This patch loads topology and maps it to IPC commands that are build the topology on the DSP. Signed-off-by:
-
Liam Girdwood authored
Add support for exposing PCMs to userspace. PCMs are defined by topology and the operations in this patch map to SOF IPC calls. The .get_module_upon_open field is set to allow for module load/unload tests. There is no risk of the sof-pci/acpi-dev module being removed while the platform components are in use. This may need to be revisited when DT platforms are supported. Signed-off-by:
-
Liam Girdwood authored
Define an IPC ABI for all host <--> DSP communication. This ABI should be transport agnostic. i.e. it should work on MMIO and SPI/I2C style interfaces. Signed-off-by:
-
Liam Girdwood authored
Add debugFS files that can be used to expose DSP memories and and peripherals to userspace to assist with firmware debugging. Since we cannot rely on debugFS, errors are logged but don't stop execution. When a resource cannot be read in D3, it is optionally cached on suspend. Copying memories from IO will increase the suspend latency, this should only used in engineering builds w/ debug options. This part will have to be enhanced when support for D0ix states is provided, currently only D0 and D3 are supported. Signed-off-by:
-
Liam Girdwood authored
SOF exposes regular ALSA Kcontrols that are defined by topology. This patch converts the Kcontrol IO to DSP IPC. The current implementation is aligned with previous Intel solutions, but is not optimal and can be improved: a) for every get/put the host wakes up the DSP and generates an IPC. The kernel should cache the values and generate an IPC only when strictly necessary. b) the firmware can be implemented to only instantiate the pipelines and related control-related parts that are needed at a given time, and power-gate the relevant SRAM blocks. The development tasks for these two improvements has started, once validated they will be provided in an update. Signed-off-by:
-
