An error occurred fetching the project authors.
- 29 May, 2005 40 commits
-
-
Clemens Ladisch authored
USB generic driver Add a mixer control map for the SB Audigy 2 NX so that we get meaningful mixer control names. Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
-
Takashi Iwai authored
VIA82xx driver Report by Ronny V. Vindenes <s864@ii.uib.no> Add dxs_support=5 for MSI K8T Neo-FIS2R. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
HDA Codec driver Fix and cleanup of CM9880 automatic PIN configuration. snd_hda_codec_setup_stream() doesn't do anything when NID is 0. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
HDA generic driver Show the jack type of each PIN default configuration entry. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
HDA generic driver Fix a typo in comments. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Karsten Wiese authored
USB generic driver,USB USX2Y Without this patch, some usb kobjects, which are parents to the usx2y's kobjects can be freed before the usx2y's. This led to an oops in get_kobj_path_length() and a dead keyboard, when the usx2y's kobjects were freed. The patch ensures the correct sequence. Tested ok on kernel 2.6.12-rc2. Signed-off-by: Karsten Wiese <annabellesgarden@yahoo.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Jesper Juhl authored
EMU10K1/EMU10K2 driver When building with gcc -W sound/pci/emu10k1/emupcm.c produces this little warning in 2.6.12-rc2-mm3 : sound/pci/emu10k1/emupcm.c:265: warning: 'inline' is not at beginning of declaration No big deal, but trivial to fix. Signed-off-by: Jesper Juhl <juhl-lkml@dif.dk> Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
VIA82xx driver Added dxs_support=5 entry for Insight P4-ITX. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
ALSA Core Increase the timer protocl number (to distinguish the fix for TREAD ioctls). Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
HDA Codec driver Misc clean up: move the definitions of constants for pinctl to a single place. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
HDA Codec driver Removed the dead (duplicated) code. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
HDA Codec driver Added the support of AD1981HD and AD1983 codecs. Including the fix for AD1986A. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Matt authored
HDA generic driver,HDA Codec driver Add initial SigmaTel codec support for 9200 and 922x. Note that this hda patch relies on the configuration default registers to be set correctly (normally by BIOS/firmware) in order for it to set up pin widgets properly. There's a test switch in the patch so it will work with the SigmaTel reference boards that are usually plugged into a system that doesn't set the configuration default registers. It supports 2 channel analog out and line/mic in. I plan to add >2 channel support and spdif support shortly. Please apply. Signed-off-by: Matt <matt@embeddedalley.com> Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Matt authored
HDA Codec driver,HDA generic driver Fix some vref defines so they are valid for the different bits in the pin cap and pin control registers. Please apply. Signed-off-by: Matt <matt@embeddedalley.com> Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
AC97 Codec The handling of shared surround/clfe output jacks with line/mic-in on some AC97 codecs is improved. Instead of 'Line-In As Surround' or 'Mic As Center/LFE' switch, two new enum controls are introduced: 'Channel Mode' and 'Surround Jack Mode'. The formar changes the current output mode among 2, 4 and 6-channels. The latter controls whether the jacks are shared or independent. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Jaroslav Kysela authored
ALSA Core Signed-off-by: Jaroslav Kysela <perex@suse.cz>
-
Takashi Iwai authored
ALSA<-OSS emulation Fix the noisy capture on some hardwares over OSS emulation. Change back to avail_min = period_size for capture direction. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
PCM Midlevel,CA0106 driver,EMU10K1/EMU10K2 driver Fix by Guillaume Chazarain <guichaz@yahoo.fr>: Some tunables in /proc have a write() function, but as their permission does not reflect it, it can be confusing to the user. So here is a patch that corrects the mode of those files. Note that I have only tested the 'xrun_debug' entry. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
EMU10K1/EMU10K2 driver Fix compile warnings regarding the unused variables/functions. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
Documentation,ALS4000 driver,ATIIXP driver,ATIIXP-modem driver AZT3328 driver,BT87x driver,CMIPCI driver,CS4281 driver ENS1370/1+ driver,ES1938 driver,ES1968 driver,FM801 driver Intel8x0 driver,Intel8x0-modem driver,Maestro3 driver,RME32 driver RME96 driver,SonicVibes driver,VIA82xx driver,VIA82xx-modem driver ALI5451 driver,au88x0 driver,CA0106 driver,CS46xx driver EMU10K1/EMU10K2 driver,HDA Intel driver,ICE1712 driver,ICE1724 driver KORG1212 driver,MIXART driver,NM256 driver,RME HDSP driver RME9652 driver,Trident driver,Digigram VX222 driver,YMFPCI driver Replace the obsolete pci_module_init() with pci_register_driver(). Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
VIA82xx driver Fix SPDIF rate setting with dxs_support=4. It should be 48k fixed. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Sergey Vlasov authored
Documentation,VIA82xx driver Add support for full sample rate conversion capabilities of DXS channels present in VIA VT8233/5/7 controllers: - any sample rate in the 8000 ... 48000 Hz range is supported even if the AC'97 codec supports only 48000 Hz output; - different DXS channels can use different sample rates at the same time (the controller performs required sample rate conversion and mixing in hardware). Signed-off-by: Sergey Vlasov <vsu@altlinux.ru> Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Sergey Vlasov authored
FM801 driver The Gallant Odyssey Sound 4 card is based on the ForteMedia FM801 chip, but has a different PCI ID. Signed-off-by: Sergey Vlasov <vsu@altlinux.ru> Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Adrian Bunk authored
YMFPCI driver This patch removes some dead code found by the Coverity checker. Signed-off-by: Adrian Bunk <bunk@stusta.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Simone Zinanni authored
ICE1712 driver Provides preliminary support for the Terratec Phase 28 card. Not extensively tested and probably buggy, but it seems to work. Signed-off-by: Simone Zinanni <simone@develer.com> Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
James Courtier-Dutton authored
EMU10K1/EMU10K2 driver when using the p16v HD device. Signed-off-by: James Courtier-Dutton <James@superbug.co.uk>
-
James Courtier-Dutton authored
EMU10K1/EMU10K2 driver Signed-off-by: James Courtier-Dutton <James@superbug.co.uk>
-
James Courtier-Dutton authored
EMU10K1/EMU10K2 driver Although we can set 44100 as the output rate, the SPDIF can do it, but the Analog output cannot. The SPDIF has the bug, whereby the Left channel arrives one sample late, so although we don't do any resampling, it is not good for AC3 non-audio output. Signed-off-by: James Courtier-Dutton <James@superbug.co.uk>
-
James Courtier-Dutton authored
EMU10K1/EMU10K2 driver Signed-off-by: James Courtier-Dutton <James@superbug.co.uk>
-
Takashi Iwai authored
HDA Codec driver Patch by C.L. Tien <cltien@cmedia.com.tw>: The patch makes cm9880 to choose multi-channel jacks automatically. 1. I found the current code has basic_init, which already includes necessary controls for 6-stack initialization, so I don't need another model. 2. I add a new model 'auto' to let the driver find a. if there are option real panel/front panel, b. the jacks to be used for multichannel. Because the jack color are based on MS's channel sequence, so the 'auto' model will pick the same jacks for multichannel MS uses. I did this to hope to minimize users questions. These code can also be applied to other codecs but I don't have any to test. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Clemens Ladisch authored
ALSA sequencer The last change to reduce stack usage did not adjust the parameter to SNDRV_SEQ_IOCTL_SET_CLIENT_IOCTL which resulted in passing the address of the pointer instead of the structure. Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
-
Sasha Khapyorsky authored
AC97 Codec Separated ac97 registers reset for audio and modem (or both) as recommended in AC97 spec. Signed-off-by: Sasha Khapyorsky <sashak@smlink.com> Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Sasha Khapyorsky authored
AC97 Codec This (especially 12000 -> 8000 sample rate replace) fix popular 'MC97 converters.. not ready' error with modem codecs initializations. Signed-off-by: Sasha Khapyorsky <sashak@smlink.com> Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Sasha Khapyorsky authored
Intel8x0-modem driver With some intel based ac97 modems codec access semaphore is not cleared after 0x54 AC97 register (GPIO_STATUS) reads. This may causes problems with newly applied modem mixer (Off-hook switch) and in other cases. Signed-off-by: Sasha Khapyorsky <sashak@smlink.com> Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
AC97 Codec - Added CM9780 patch - Fix the SPDIF support on CM9761/CM9780 - Allow the generic enum callback to pass any number (not power of 2) as the value mask Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
AC97 Codec Removed unused variables (the old control definitions). Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Takashi Iwai authored
EMU10K1/EMU10K2 driver Check ther revision to detect non-listed audigy 2 boards. Signed-off-by: Takashi Iwai <tiwai@suse.de>
-
Clemens Ladisch authored
USB generic driver This patch adds quirks to support 24-bit PCM I/O in the 'Advanced Driver' mode of the BOSS GS-10. Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
-
Clemens Ladisch authored
ALSA sequencer The last change to reduce stack usage did not adjust the parameter to SNDRV_SEQ_IOCTL_CREATE_PORT which resulted in passing the address of the pointer instead of the structure. Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
-
Jaroslav Kysela authored
Timer Midlevel Signed-off-by: Jaroslav Kysela <perex@suse.cz>
-