Call the 64bit versions of rtc_tm time conversion now that the range is
enforced by the core.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

From the datasheet: "HW_RTC_SECONDS provides access to the 32-bit real-time
seconds counter."
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Use SPDX-License-Identifier instead of a verbose license text.
Acked-by: Thierry Reding <treding@nvidia.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Call the 64bit versions of rtc_tm time conversion now that the range is
enforced by the core.
Acked-by: Thierry Reding <treding@nvidia.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

The Tegra 20 RTC is a 32bit seconds counter (with an unused millisecond
counter).
Acked-by: Thierry Reding <treding@nvidia.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Use SPDX-License-Identifier instead of the custom license line.
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Use .set_time instead of the deprecated .set_mmss.
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Call the 64bit versions of rtc_tm time conversion now that the range is
enforced by the core.
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

The COH 901 331 is a 32bit seconds counter.
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Use %ptR to simplify debug message.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Use SPDX-License-Identifier instead of a verbose license text.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Use .set_time instead of the deprecated .set_mmss.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Use the 64bit version of rtc_time_to_tm.rtc_time_to_tm.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

ds1672_get_datetime and ds1672_set_mmss are only used after casting dev
to an i2c_client. Remove that useless indirection.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Remove the control sysfs file as it is not documented, read only and was
only used to provide the oscillator state.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Return -EINVAL when trying to read an invalid time instead of just probe
because this is a useful information for userspace.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

The ds1672 is a 32bit seconds counter.

Also remove erroneous comment claiming that epoch is set to 2000, it was
not.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Use .set_time instead of the deprecated .set_mmss64.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

When setting rtc alarm (RTC_WKALM_SET), the tm_year is not checked if it
is in suiteable range. Use INT_MAX - 1900 to check it.

UBSAN: Undefined behaviour in drivers/rtc/rtc-lib.c:119:30
signed integer overflow:
2147483647 + 1900 cannot be represented in type 'int'
CPU: 1 PID: 20994 Comm: syz-executor0 Not tainted 4.19.18-514.55.6.9.x86_64
+ #1
Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 1.10.2-1ubuntu1
04/01/2014
Call Trace:
 __dump_stack lib/dump_stack.c:77 [inline]
 dump_stack+0xca/0x13e lib/dump_stack.c:113
 ubsan_epilogue+0xe/0x81 lib/ubsan.c:159
 handle_overflow+0x193/0x1e2 lib/ubsan.c:190
 rtc_tm_to_time64+0x267/0x280 drivers/rtc/rtc-lib.c:119
 rtc_tm_to_ktime+0x16/0x70 drivers/rtc/rtc-lib.c:129
 rtc_set_alarm+0x1a9/0x2d0 drivers/rtc/interface.c:466
 rtc_dev_ioctl+0x6db/0x810 drivers/rtc/rtc-dev.c:380
 vfs_ioctl fs/ioctl.c:46 [inline]
 do_vfs_ioctl+0x1a5/0x10b0 fs/ioctl.c:690
 ksys_ioctl+0x89/0xa0 fs/ioctl.c:705
 __do_sys_ioctl fs/ioctl.c:712 [inline]
 __se_sys_ioctl fs/ioctl.c:710 [inline]
 __x64_sys_ioctl+0x74/0xb0 fs/ioctl.c:710
 do_syscall_64+0xc8/0x580 arch/x86/entry/common.c:290
 entry_SYSCALL_64_after_hwframe+0x49/0xbe
RIP: 0033:0x462589
Code: f7 d8 64 89 02 b8 ff ff ff ff c3 66 0f 1f 44 00 00 48 89
f8 48 89 f7 48 89 d6 48 89 ca 4d 89 c2 4d 89 c8 4c 8b 4c 24 08
0f 05 <48> 3d 01 f0 ff ff 73 01 c3 48 c7 c1 bc ff ff ff f7 d8
64 89 01 48
RSP: 002b:00007f5348896c58 EFLAGS: 00000246 ORIG_RAX: 0000000000000010
RAX: ffffffffffffffda RBX: 000000000072bf00 RCX: 0000000000462589
RDX: 0000000020000000 RSI: 000000004028700f RDI: 0000000000000003
RBP: 0000000000000003 R08: 0000000000000000 R09: 0000000000000000
R10: 0000000000000000 R11: 0000000000000246 R12: 00007f53488976bc
R13: 00000000004bf67e R14: 00000000006f96e0 R15: 00000000ffffffff

==========================================================================
Signed-off-by: Xuefeng Wang <wxf.wang@hisilicon.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

The mentioned function pointer is long gone since early 2011. Remove the
reference in the comment and reword it slightly.

Fixes: 51ba60c5 ("RTC: Cleanup rtc_class_ops->update_irq_enable()")
Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Remove the unused "depends on I2C" as the config options are already
guarded by if I2C.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Allow reading the oscillator status bit. Also allow clearing it even if
that makes little sense and can't be done in a race free way.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

The PCF850363 has an offset correction with two modes:

With mode 0, the correction is triggered once every two hours and then
correction pulses are applied once per minute until the programmed
correction values have been implemented. This gives a step of 4.34 ppm.

With mode 1, the correction is triggered once every four minutes and then
correction pulses are applied once per second up to a maximum of 60 pulses.
When correction values greater than 60 pulses are used, additional
correction pulses are made in the 59 th second. This gives a step of 4.069
ppm.

Use the correction closest to the requested value.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

The pcf85063 has one byte of nvram.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

The Micro Crystal RV8263 has the same IC as the pcf85063 but has an on
board crystal. This means that the CAP_SEL bit has to be cleared so the
correct capacitance is selected for the crystal.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Add support for the alarms. The match on the weekday is not used as it it
not necessarily properly set.

The tested RTC shows a behaviour where setting an alarm on the second right
after an alarm that fired is not working, probably because of the circuit
that ensures an alarm only fires once. This is why uie_unsupported is set.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

As stated in a comment pcf85063a and pcf85063tp don't have the same number
of registers. Especially, pcf85063tp doesn't have alarm support.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Switch to regmap to simplify register accesses and remove the need for
pcf85063_stop_clock/pcf85063_start_clock.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

This is a standard BCD RTC that will fail in 2100.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

This allows further improvement of the driver.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Only smbus reads and write are done in the driver, plain i2c functionality
is not required.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Use SPDX-License-Identifier instead of a verbose license text.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

struct i2c_device_id argument of probe() is not used, so use probe_new()
instead.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Use the new helper devm_platform_ioremap_resource() which wraps the
platform_get_resource() and devm_ioremap_resource() together, to
simplify the code.
Signed-off-by: Anson Huang <Anson.Huang@nxp.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Use the new helper devm_platform_ioremap_resource() which wraps the
platform_get_resource() and devm_ioremap_resource() together, to
simplify the code.
Signed-off-by: Anson Huang <Anson.Huang@nxp.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

With calling dev_pm_set_wake_irq() to set SNVS RTC as wakeup
source for suspend, generic wake irq mechanism will automatically
enable it as wakeup source when suspend, then the suspend/resume
callback which are ONLY for enabling/disabling irq wake can be
removed, it simplifies the code.
Signed-off-by: Anson Huang <Anson.Huang@nxp.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Read and writes the time to the non-battery backed RTC in the ASPEED BMC
system on chip families.
Signed-off-by: Joel Stanley <joel@jms.id.au>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Describe the RTC as used in the ASPEED BMC SoCs.
Signed-off-by: Joel Stanley <joel@jms.id.au>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Call the 64bit version of rtc_time_to_tm as the range is enforced by the
core.
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

The IRQ mapping was changed to not being created in the rtc-mt6397
driver, so the irq_dispose_mapping is no longer needed.
Also the dev_id passed to free_irq should be the same as the last
argument passed to request_threaded_irq.
This prevents a "Trying to free already-free IRQ 274" warning when
unbinding the driver.

Fixes: e695d3a0 ("mfd: mt6397: Create irq mappings in mfd core driver")
Signed-off-by: Pi-Hsun Shih <pihsun@chromium.org>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>