- 07 Jan, 2009 40 commits
-
-
Hans de Goede authored
Simplify fan and temp hyst. handling by treating the registers as an array of nibbles instead of using switch cases. Also unify the way hysts are handled between temp and fans, the temp code was storing the actual per temp hyst values in 4 u8's, where as the fan code was storing actual register values. Signed-off-by:
Hans de Goede <hdegoede@redhat.com> Signed-off-by:
Jean Delvare <khali@linux-fr.org>
-
Hans de Goede authored
While working on adding F8000 support I noticed that various of the store sysfs functions (and a few of the show also) had issues. This patch fixes the following issues in these functions: * store: storing the result of strto[u]l in an int, resulting in a possible overflow before boundary checking * store: use of f71882fg_update_device(), we don't want to read the whole device in store functions, just the registers we need * store: use of cached register values instead of reading the needed regs in the store function, including cases where f71882fg_update_device() was not used, this could cause real isues * show: shown value is a calculation of 2 or more cached register reads, without locking the data struct. Signed-off-by:
-
Hans de Goede authored
This patch is a preparation patch for adding F8000 support to the f71882fg driver. If you look at the register addresses and esp, the bits used for the temperature channels, then you will notice that it appears that they start at 1 in a system meant to start at 0. As the F8000 actually uses the 0 addresses and bits, this patch changes the f71882fg driver to take 4 temperatures numbered 0-3 in to account, using 1-3 in this new scheme for the temperatures actually present in the F718x2FG. Signed-off-by:
-
Hans de Goede authored
The f71882fg driver did some io to ioports it hadn't reserved yet in its find (detect) function, this patches moves this io to the probe function where these ports are reserved and this io belongs. Signed-off-by:
-
Hans de Goede authored
This patch adds support for the Fintek f71862fg superio monitoring functions to the f71882fg driver. This support has been tested without problems on a Jetway J9F2 by Tony McConnell. Signed-off-by:
-
Hans de Goede authored
Various small cleanups as preparation for adding f71862fg support to the f71882fg driver. Signed-off-by:
-
Mark van Doesburg authored
Add PWM (fan speed control) support to the f71882fg driver. Both manual control and automatic (temperature-based) modes are supported. Additionally, each mode has a PWM-based and an RPM-based variant. By default we use the mode set by the BIOS. Signed-off-by:
-
Mark van Doesburg authored
A few cleanups that were originally part of a larger patch but are better submitted separately. Signed-off-by:
-
Mark van Doesburg authored
Convert f71882fg driver from SENSOR_ATTR to SENSOR_ATTR2 use, this is a preparation patch for adding pwm support, which is broken out to make what changes really in the pwm support patch clear. Signed-off-by:
-
Linus Torvalds authored
The __SWAB_64_THRU_32__ case of a 64-bit byte swap was depending on the no-longer-existant ___swab32() method (three underscores). We got rid of some of the worst indirection and complexity, and now it should just use the 32-bit swab function that was defined right above it. Reported-and-tested-by:
Nicolas Pitre <nico@cam.org> Reported-by:
Benjamin Herrenschmidt <benh@kernel.crashing.org> Cc: Harvey Harrison <harvey.harrison@gmail.com> Signed-off-by:
Linus Torvalds <torvalds@linux-foundation.org>
-
Harvey Harrison authored
This implementation caused problems in userspace which can, and does define _both_ __LITTLE_ENDIAN and __BIG_ENDIAN. Signed-off-by:
Harvey Harrison <harvey.harrison@gmail.com> Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
-
Harvey Harrison authored
The first step to make swab.h a regular header that will include an asm/swab.h with arch overrides. Avoid the gratuitous differences introduced in the new linux/swab.h by naming the ___constant_swabXX bits and __fswabXX bits exactly as found in the old implementation in byteorder/swab[b].h Use this new swab.h in byteorder/[big|little]_endian.h and remove the two old swab headers. Although the inclusion of asm/byteorder.h looks strange in linux/swab.h, this will allow each arch to move the actual arch overrides for the swab bits in an asm file and then the includes can be cleaned up without requiring a flag day for all arches at once. Keep providing __fswabXX in case some userspace was using them directly, but the revised __swabXX should be used instead in any new code and will always do constant folding not dependent on the optimization level, which means the __constant versions can be phased out in-kernel. Arches that use the old-style arch macros will lose their optimized versions until they move to the new style, but at least they will still compile. Many arches have already moved and the patches to move the remaining arches are trivial. Signed-off-by:
-
git://git.kernel.org/pub/scm/linux/kernel/git/airlied/drm-2.6Linus Torvalds authored
* 'drm-next' of git://git.kernel.org/pub/scm/linux/kernel/git/airlied/drm-2.6: drm: fix ordering of driver unload vs agp unload. drm/i915: Respect the other stolen memory sizes we know of. drm/i915: Non-mobile parts don't have integrated TV-out. drm/i915: Add support for integrated HDMI on G4X hardware. drm/i915: Pin cursor bo and unpin old bo when setting cursor. drm/i915: Don't allow objects to get bound while VT switched.
-
Dave Airlie authored
For KMS drivers, we really need to cleanup the driver before disabling the AGP subsystem. Signed-off-by:Dave Airlie <airlied@redhat.com>
-
Eric Anholt authored
fd.o bug #19336. Signed-off-by:
Eric Anholt <eric@anholt.net> Signed-off-by:
Dave Airlie <airlied@linux.ie>
-
Eric Anholt authored
Signed-off-by:
-
Eric Anholt authored
This is ported directly from the userland 2D driver code. The HDMI audio bits aren't hooked up yet. Signed-off-by:
-
Kristian Høgsberg authored
We also didn't track the cursor bo before and would leak a reference when the cursor image was change. Signed-off-by:
Kristian Høgsberg <krh@redhat.com> Signed-off-by:
-
Eric Anholt authored
This avoids a BUG_ON in the enter_vt path due to objects being in the GTT when we shouldn't have ever let them be (as we're not supposed to touch the device during that time). This was triggered by a change in the 2D driver to use the GTT mapping of objects after pinning them to improve software fallback performance. Signed-off-by:
-
git://git.kernel.org/pub/scm/linux/kernel/git/dtor/inputLinus Torvalds authored
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input: (29 commits) Input: i8042 - add Dell Vostro 1510 to nomux list Input: gtco - use USB endpoint API Input: add support for Maple controller as a joystick Input: atkbd - broaden the Dell DMI signatures Input: HIL drivers - add MODULE_ALIAS() Input: map_to_7segment.h - convert to __inline__ for userspace Input: add support for enhanced rotary controller on pxa930 and pxa935 Input: add support for trackball on pxa930 and pxa935 Input: add da9034 touchscreen support Input: ads7846 - strict_strtoul takes unsigned long Input: make some variables and functions static Input: add tsc2007 based touchscreen driver Input: psmouse - add module parameters to control OLPC touchpad delays Input: i8042 - add Gigabyte M912 netbook to noloop exception table Input: atkbd - Samsung NC10 key repeat fix Input: atkbd - add keyboard quirk for HP Pavilion ZV6100 laptop Input: libps2 - handle 0xfc responses from devices Input: add support for Wacom W8001 penabled serial touchscreen Input: synaptics - report multi-taps only if supported by the device Input: add joystick driver for Walkera WK-0701 RC transmitter ...
-
Linus Torvalds authored
Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jmorris/security-testing-2.6 * 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jmorris/security-testing-2.6: CRED: Fix regression in cap_capable() as shown up by sys_faccessat() [ver #3] Revert "CRED: Fix regression in cap_capable() as shown up by sys_faccessat() [ver #2]" SELinux: shrink sizeof av_inhert selinux_class_perm and context CRED: Fix regression in cap_capable() as shown up by sys_faccessat() [ver #2] keys: fix sparse warning by adding __user annotation to cast smack: Add support for unlabeled network hosts and networks selinux: Deprecate and schedule the removal of the the compat_net functionality netlabel: Update kernel configuration API
-
Linus Torvalds authored
Merge branch 'timers-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip * 'timers-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip: hrtimer: splitout peek ahead functionality, fix hrtimer: fixup comments hrtimer: fix recursion deadlock by re-introducing the softirq hrtimer: simplify hotplug migration hrtimer: fix HOTPLUG_CPU=n compile warning hrtimer: splitout peek ahead functionality
-
Linus Torvalds authored
Merge branch 'sched-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip * 'sched-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip: sched: fix section mismatch sched: fix double kfree in failure path sched: clean up arch_reinit_sched_domains() sched: mark sched_create_sysfs_power_savings_entries() as __init getrusage: RUSAGE_THREAD should return ru_utime and ru_stime sched: fix sched_slice() sched_clock: prevent scd->clock from moving backwards, take #2 sched: sched.c declare variables before they get used
-
