- 27 Oct, 2009 13 commits
-
-
Juuso Oikarinen authored
Corrections to the TX path - use correct number of maximum descriptors (32 instead of 16) and correct checking and setting of excessive retries on completion. Signed-off-by:
Juuso Oikarinen <juuso.oikarinen@nokia.com> Reviewed-by:
Luciano Coelho <luciano.coelho@nokia.com> Signed-off-by:
John W. Linville <linville@tuxdriver.com>
-
Juuso Oikarinen authored
Update the usage of join's, including using actual beacon interval and dtim from AP, and configuring a basic rate set from AP. Signed-off-by:
-
Juuso Oikarinen authored
Configure the rate policies to the firmware based on the rates given by the AP. Signed-off-by:
-
Juuso Oikarinen authored
This patch adds implementation for checking for SPI busy words - i.e. honoring a delay request from the WLAN chipset upon reading registers/memory. To optimized the average SPI ready by 32 bits, also configure the number of busywords to one to disable the "fixed-busy-word" functionality. Signed-off-by:
Vidhya Govindan <vidhya.govindan@nokia.com> Signed-off-by:
-
Juuso Oikarinen authored
In ps-poll template aid bits 14 and 15 were not masked as required by the standard. Mask them so that aid is sent in correct format. This patch is a direct port of the respective patch for the wl1251 driver by Kalle Valo. Signed-off-by:
-
Juuso Oikarinen authored
Implement delayed entry into ELP. This will promote the following: - Less redundant sleep/wake cycles (better perf) - Avoids known firmware issues with going to ELP too fast after an operation Signed-off-by:
-
Juuso Oikarinen authored
Correct the position to which TKIP header space is appended for TX packets. Signed-off-by:
-
Juuso Oikarinen authored
Add security sequence number handling to the driver TX data path needed by WPA. Signed-off-by:
Kalle Valo <kalle.valo@nokia.com> Signed-off-by:
-
Juuso Oikarinen authored
Correct the TX path implementation to allocate sufficient blocks in the firmware for TX packets. Signed-off-by:
-
Luciano Coelho authored
The qual element in ieee80211_rx_status is not used anymore, so we don't need to set it in the wl1271_rx_status() function. This saves a bit of time in the RX path. Signed-off-by:
-
David Kilroy authored
Signed-off-by:
David Kilroy <kilroyd@googlemail.com> Signed-off-by:
-
Luis R. Rodriguez authored
The PA calibration for ar9271 ath9k_hw_9271_pa_cal() can run during reset or initial calibration, update the PA calibration to account for that and initialize PA calibration variables for both conditions. Signed-off-by:
Luis R. Rodriguez <lrodriguez@atheros.com> Signed-off-by:
-
Luis R. Rodriguez authored
This is required for the ar9271 hardware as well. Signed-off-by:
-
- 24 Oct, 2009 27 commits
-
-
Ben Hutchings authored
The 'XFP' driver is really a driver for the QT2022C2 and QT2025C PHYs, covering both more and less than XFP. Rename its functions and constants to reflect reality and to reduce namespace pollution when sfc is a built-in driver. Signed-off-by:
Ben Hutchings <bhutchings@solarflare.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Ben Hutchings authored
The only multi-speed PHY driver using this is 10Xpress, and it does not support non-autoneg operation. Signed-off-by:
-
Ben Hutchings authored
efx_fc_resolve() is specific to MDIO and is not used by any other function. Signed-off-by:
-
Ben Hutchings authored
The MTD partition is named based on the netdev name, which is set to 'eth%d' before registration. Also, the MTD partition will currently be left registered if netdev registration fails. Fix both these problems by moving the MTD probe after netdev registration. Hold the RTNL to serialise this with the netdev notifier that calls efx_mtd_rename(). Signed-off-by:
-
Ben Hutchings authored
These cleanup functions will never be called if the MMIO region could not be mapped. Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
MAC and PHY probing are bound up together, as evidenced by the initialisation of efx_nic::loopback_modes. Remove the current arbitrary separation. Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
This simplifies the implementation a lot. Signed-off-by:
-
Ben Hutchings authored
These will also be used with Siena NICs. Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
This makes efx_pci_remove_main() more obviously the inverse of efx_pci_probe_main(), and matches our out-of-tree driver. Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Replace the duplicated logic in efx_enqueue_skb() and efx_tx_queue_insert() with an inline function, efx_max_tx_len(). Remove the failed attempt at abstracting hardware-specifics and put all the magic numbers in efx_max_tx_len(). Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Move size and mask definitions into efx.h; calculate page orders in falcon.c. Signed-off-by:
-
Ben Hutchings authored
While we're at it, use type suffixes of 'd', 'q' and 'o', consistent with register type names. Signed-off-by:
-
Ben Hutchings authored
Siena is still based on the Falcon hardware architecture and will share many of these definitions, so replace falcon_hwdefs.h with regs.h. The new definitions have been generated according to a naming convention which incorporates the type and revision information. Update the code accordingly. Signed-off-by:
-
Ben Hutchings authored
Since there are now separate blocks of code to set the thresholds for each NIC type, it is no longer useful to include them in the NIC type description. Signed-off-by:
-
Ben Hutchings authored
These macros are not extensible to more than two NIC types without repetition of register definitions, and they are only used to deal with a few fields in RX_CFG_REG and global events which moved between Falcon rev A1 and B0. Therefore: - Move RX_CFG_REG initialisation into its own function which tests the NIC revision just once - Explicitly test the NIC revision when checking the RX_RECOVERY flag in global events - Merge definitions of RX_XOFF_MAC_EN flag, which did not move - Remove the macro definitions Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Siena will require entirely different board code. Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
