net: phy: icplus: fix broken INTR pin settings

This patch fixes the setting of the INTR pin that is
valid for IP101 A/G device and not for the IP1001.
Reported-by: Anunay Saxena <anunay.saxena@st.com>
Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/phy/icplus.c

@@ -139,11 +139,6 @@ static int ip1001_config_init(struct phy_device *phydev)
 	if (c < 0)
 		return c;
 
-	/* INTR pin used: speed/link/duplex will cause an interrupt */
-	c = phy_write(phydev, IP101A_G_IRQ_CONF_STATUS, IP101A_G_IRQ_DEFAULT);
-	if (c < 0)
-		return c;
-
 	if ((phydev->interface == PHY_INTERFACE_MODE_RGMII) ||
 	    (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID) ||
 	    (phydev->interface == PHY_INTERFACE_MODE_RGMII_RXID) ||
@@ -178,6 +173,11 @@ static int ip101a_g_config_init(struct phy_device *phydev)
 	if (c < 0)
 		return c;
 
+	/* INTR pin used: speed/link/duplex will cause an interrupt */
+	c = phy_write(phydev, IP101A_G_IRQ_CONF_STATUS, IP101A_G_IRQ_DEFAULT);
+	if (c < 0)
+		return c;
+
 	/* Enable Auto Power Saving mode */
 	c = phy_read(phydev, IP10XX_SPEC_CTRL_STATUS);
 	c |= IP101A_G_APS_ON;