ARM: shmobile: r8a73a4 dtsi: Add missing "gpio-ranges" to gpio node

If a GPIO driver uses gpiochip_add_pin_range() (which is usually the
case for GPIO/PFC combos), the GPIO hogging mechanism configured from DT
doesn't work:

    requesting hog GPIO led1-high (chip r8a73a4_pfc, offset 28) failed

The actual error code is -517 == -EPROBE_DEFER.

The problem is that PFC+GPIO registration is handled in multiple steps:
  1. pinctrl_register(),
  2. gpiochip_add(),
  3. gpiochip_add_pin_range().

Configuration of the hogs is handled in gpiochip_add():

    gpiochip_add
        of_gpiochip_add
            of_gpiochip_scan_hogs
                gpiod_hog
                    gpiochip_request_own_desc
                        __gpiod_request
                            chip->request
                                pinctrl_request_gpio
                                    pinctrl_get_device_gpio_range

However, at this point the GPIO controller hasn't been added to
pinctrldev_list yet, so the range can't be found, and the operation fails
with -EPROBE_DEFER.

To fix this, add a "gpio-ranges" property to the gpio device node, so
the ranges are added by of_gpiochip_add_pin_range(), which is called by
of_gpiochip_add() before the call to of_gpiochip_scan_hogs().
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Acked-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Simon Horman <horms+renesas@verge.net.au>

arch/arm/boot/dts/r8a73a4.dtsi

@@ -207,6 +207,13 @@ pfc: pfc@e6050000 {
 		reg = <0 0xe6050000 0 0x9000>;
 		gpio-controller;
 		#gpio-cells = <2>;
+		gpio-ranges =
+			<&pfc 0 0 31>, <&pfc 32 32 9>,
+			<&pfc 64 64 22>, <&pfc 96 96 31>,
+			<&pfc 128 128 7>, <&pfc 160 160 19>,
+			<&pfc 192 192 31>, <&pfc 224 224 27>,
+			<&pfc 256 256 28>, <&pfc 288 288 21>,
+			<&pfc 320 320 10>;
 		interrupts-extended =
 			<&irqc0  0 0>, <&irqc0  1 0>, <&irqc0  2 0>, <&irqc0  3 0>,
 			<&irqc0  4 0>, <&irqc0  5 0>, <&irqc0  6 0>, <&irqc0  7 0>,