Commit 505a8680 authored by Shawn Guo's avatar Shawn Guo Committed by Chris Ball

mmc: sdhci: query card presence from cd-gpio before asking SDHCI

Call mmc_gpio_get_cd() to query card presence from cd-gpio before
asking SDHCI.  The rationale behind this change is that flag
SDHCI_QUIRK_BROKEN_CARD_DETECTION is designed for SDHCI controller to
tell that SDHCI_PRESENT_STATE is broken, and it should be used for this
case only.  So when cd-gpio is being used, the controller should set
the flag to tell that SDHCI_PRESENT_STATE is not available.

However, the existing code will skip checking cd-gpio as long as flag
SDHCI_QUIRK_BROKEN_CARD_DETECTION is set.  Change the querying order
between cd-gpio and SDHCI to support the rationale above.
Signed-off-by: default avatarShawn Guo <shawn.guo@linaro.org>
Signed-off-by: default avatarChris Ball <cjb@laptop.org>
parent 77e2ff08
......@@ -1258,7 +1258,7 @@ static int sdhci_set_power(struct sdhci_host *host, unsigned short power)
static void sdhci_request(struct mmc_host *mmc, struct mmc_request *mrq)
{
struct sdhci_host *host;
bool present;
int present;
unsigned long flags;
u32 tuning_opcode;
......@@ -1287,18 +1287,21 @@ static void sdhci_request(struct mmc_host *mmc, struct mmc_request *mrq)
host->mrq = mrq;
/* If polling, assume that the card is always present. */
if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION)
present = true;
else
present = sdhci_readl(host, SDHCI_PRESENT_STATE) &
SDHCI_CARD_PRESENT;
/* If we're using a cd-gpio, testing the presence bit might fail. */
if (!present) {
int ret = mmc_gpio_get_cd(host->mmc);
if (ret > 0)
present = true;
/*
* Firstly check card presence from cd-gpio. The return could
* be one of the following possibilities:
* negative: cd-gpio is not available
* zero: cd-gpio is used, and card is removed
* one: cd-gpio is used, and card is present
*/
present = mmc_gpio_get_cd(host->mmc);
if (present < 0) {
/* If polling, assume that the card is always present. */
if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION)
present = 1;
else
present = sdhci_readl(host, SDHCI_PRESENT_STATE) &
SDHCI_CARD_PRESENT;
}
if (!present || host->flags & SDHCI_DEVICE_DEAD) {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment