The arm clock semaphores are strict mutexes, convert them to the new
mutex implementation
Signed-off-by: Arjan van de Ven <arjan@infradead.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

This is part of a patch from Marc Singer to allow r2 to be
passed to the kernel.  Marc's original comments follow:

This revised R2 (atags pointer) patch incorporates comments from Nico
Pitre and Ben Dooks. It modifies the head.S files such that the R2
value set by the bootloader is conveyed to the kernel startup code.
The kernel head.S heuristically validates the pointer. It will set R2
to zero if it believes the pointer is invalid. Presently, it requires
that the ATAGS list reside in the first 16KiB of physical RAM.
Relaxing this contraint may be both desirable as well as tricky.
Signed-off-by: Marc Singer <elf@buici.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Catalin Marinas

If the low interrupt latency mode is enabled for the CPU (from ARMv6
onwards), the ldm/stm instructions are no longer atomic. An ldm instruction
restoring the sp and pc registers can be interrupted immediately after sp
was updated but before the pc. If this happens, the CPU restores the base
register to the value before the ldm instruction but if the base register
is not sp, the interrupt routine will corrupt the stack and the restarted
ldm instruction will load garbage.

Note that future ARM cores might always run in the low interrupt latency
mode.
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Richard Purdie

This patch adds a check to see if the pxa i2c interface is enabled
before allowing it to be used and resets it if found to be disabled.
This automatically restores the interface if the device has been
suspended and resumed without causing any suspend/resume call ordering
issues.

The patch also fixes a build warning and adds an appropriate module
licence (the module is gpl according to the header).
Signed-off-by: Richard Purdie <rpurdie@rpsys.net>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Catalin Marinas

Since ARM1176, the CPU ID format has changed and it will also be used for
future ARM architectures.
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Kevin Hilman

This patch increase available DMA-consistent memory allocated by dma_coherent_alloc(). The default remains at 2M (defined in asm/memory.h) and each platform has the ability to override in asm/arch-foo/memory.h.
Signed-off-by: Kevin Hilman <kevin@hilman.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Nicolas Pitre

Depending on your gcc version, the current C-only implementation would
produce suboptimal code, ranging from a bad register selection forcing
an additional mov instruction to a failure to merge the eor and the ror
in a single instruction.  With a little help gcc always produces the
best code.
Signed-off-by: Nicolas Pitre <nico@cam.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Richard Purdie

Change mainstone and sharpsl pxa2xx pcmcia drivers to use
platform_device_alloc which fixes a memory leak.
Signed-off-by: Richard Purdie <rpurdie@rpsys.net>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

	#3244)

Patch from Andrew Victor

This patch adds support to the 2.6 kernel series for the Atmel
AT91RM9200 processor.

This patch is the support for the Cogent CSB337 and CSB637 boards.
Signed-off-by: Andrew Victor <andrew@sanpeople.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Andrew Victor

This patch adds support to the 2.6 kernel series for the Atmel
AT91RM9200 processor.

This patch is the support for Atmel's DK and EK boards.
Signed-off-by: Andrew Victor <andrew@sanpeople.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Andrew Victor

This patch adds support to the 2.6 kernel series for the Atmel
AT91RM9200 processor.

This patch is the Serial driver.

This version uses the newly re-written GPL'ed hardware headers.
Signed-off-by: Andrew Victor <andrew@sanpeople.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

I think it is better to set ->next_pending in the caller, when
it is needed. This saves one parameter, and this coincides with
cpu_quiet() beahaviour, which sets ->completed = ->cur itself.
Signed-off-by: Oleg Nesterov <oleg@tv-sign.ru>
Acked-by: Paul E. McKenney <paulmck@us.ibm.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

convert the block loop device from semaphores to completions.
Signed-off-by: Ingo Molnar <mingo@elte.hu>

The patch changes semaphores that are initialized as
locked to complete().

Source: MontaVista Software, Inc.
Modified-by: Steven Rostedt <rostedt@goodmis.org>

The following patch is from Montavista.  I modified it slightly.
Semaphores are currently being used where it makes more sense for
completions.  This patch corrects that.
Signed-off-by: Aleksey Makarov <amakarov@ru.mvista.com>
Signed-off-by: Steven Rostedt <rostedt@goodmis.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>

change CPU3WDT semaphores to completions.
Signed-off-by: Ingo Molnar <mingo@elte.hu>

change SX8 semaphores to completions.
Signed-off-by: Ingo Molnar <mingo@elte.hu>

This patch converts the superblock-lock semaphore to a mutex, affecting
lock_super()/unlock_super(). Tested on ext3 and XFS.
Signed-off-by: Ingo Molnar <mingo@elte.hu>

This patch converts the inode semaphore to a mutex. I have tested it on
XFS and compiled as much as one can consider on an ia64. Anyway your
luck with it might be different.
Modified-by: Ingo Molnar <mingo@elte.hu>

(finished the conversion)
Signed-off-by: Jes Sorensen <jes@sgi.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>

This patch switches XFS over to use the new mutex code directly as
opposed to the previous workaround patch I posted earlier that avoided
the namespace clash by forcing it back to semaphores. This falls in the
'works for me<tm>' category.
Signed-off-by: Jes Sorensen <jes@trained-monkey.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>

more mutex debugging: check for held locks during memory freeing,
task exit, enable sysrq printouts, etc.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Arjan van de Ven <arjan@infradead.org>

mutex implementation - add debugging code.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Arjan van de Ven <arjan@infradead.org>

Add mutex design related documentation.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Arjan van de Ven <arjan@infradead.org>

mutex implementation, core files: just the basic subsystem, no users of it.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Arjan van de Ven <arjan@infradead.org>

add the per-arch mutex.h files for the remaining architectures.

We default to asm-generic/mutex-dec.h, because that performs
quite well on most arches. Arches that do not have atomic
decrement/increment instructions should switch to mutex-xchg.h
instead. Arches can also provide their own implementation for
the mutex fastpath primitives.
Signed-off-by: Arjan van de Ven <arjan@infradead.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>

add the ARM version of mutex.h, which is optimized in assembly for
ARMv6, and uses the xchg implementation on pre-ARMv6.
Signed-off-by: Ingo Molnar <mingo@elte.hu>

add the x86_64 version of mutex.h, optimized in assembly.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Arjan van de Ven <arjan@infradead.org>

add the i386 version of mutex.h, optimized in assembly.
Signed-off-by: Arjan van de Ven <arjan@infradead.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>

Add three (generic) mutex fastpath implementations.

The mutex-xchg.h implementation is atomic_xchg() based, and should
work fine on every architecture.

The mutex-dec.h implementation is atomic_dec_return() based - this
one too should work on every architecture, but might not perform the
most optimally on architectures that have no atomic-dec/inc instructions.

The mutex-null.h implementation forces all calls into the slowpath. This
is used for mutex debugging, but it can also be used on platforms that do
not want (or need) a fastpath at all.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Arjan van de Ven <arjan@infradead.org>

add typecheck_fn(type, function) to do type-checking of function
pointers.
Modified-by: Ingo Molnar <mingo@elte.hu>

(made it typeof() based, instead of typedef based.)
Signed-off-by: Chuck Ebbert <76306.1226@compuserve.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>

add atomic_xchg() to all the architectures. Needed by the new mutex code.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Arjan van de Ven <arjan@infradead.org>

Here's a small patch with a few tiny fixups for the EHCI Kconfig help
text. Please consider applying.
Signed-off-by: Jesper Juhl <juhl-lkml@dif.dk>
Signed-off-by: Adrian Bunk <bunk@stusta.de>

Signed-off-by: Adrian Bunk <bunk@stusta.de>

This patch removes two outdated changelog files.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Dave Jones <davej@redhat.com>

Leonard N. Zubkoff passed away in August 2002.
Signed-off-by: Adrian Bunk <bunk@stusta.de>

Additionally, one comment was reformulated by Joe Perches <joe@perches.com>.
Signed-off-by: Adrian Bunk <bunk@stusta.de>