The start_tx and stop_tx methods were passed a flag to indicate
whether the start/stop was from the tty start/stop callbacks, and
some drivers used this flag to decide whether to ask the UART to
immediately stop transmission (where the UART supports such a
feature.)

There are other cases when we wish this to occur - when CTS is
lowered, or if we change from soft to hard flow control and CTS
is inactive.  In these cases, this flag was false, and we would
allow the transmitter to drain before stopping.

There is really only one case where we want to let the transmitter
drain before disabling, and that's when we run out of characters
to send.

Hence, re-jig the start_tx and stop_tx methods to eliminate this
flag, and introduce new functions for the special "disable and
allow transmitter to drain" case.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

The following patch fixes two warnings in arch/ppc/syslib/m8xx_setup.c
Signed-off-by: Marcelo Tosatti <marcelo.tosatti@cyclades.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

I had some time to think about PCI assign issues in 2.6.13-rc series.

The major problem here is that we call pci_assign_unassigned_resources()
way too early - at subsys_initcall level. Therefore we give no chances
to ACPI and PnP routines (called at fs_initcall level) to reserve their
respective resources properly, as the comments in drivers/pnp/system.c
and drivers/acpi/motherboard.c suggest:

 /**
  * Reserve motherboard resources after PCI claim BARs,
  * but before PCI assign resources for uninitialized PCI devices
  */

So I moved the pci_assign_unassigned_resources() call to
pcibios_assign_resources() (fs_initcall), which should hopefully fix a
lot of problems and make PCIBIOS_MIN_IO tweaks unnecessary.

Other changes:
- remove resource assignment code from pcibios_assign_resources(), since
  it duplicates pci_assign_unassigned_resources() functionality and
  actually does nothing in 2.6.13;
- modify ROM assignment code as per Ben's suggestion: try to use firmware
  settings by default (if PCI_ASSIGN_ROMS is not set);
- set CARDBUS_IO_SIZE back to 4K as it's a wonderful stress test for
  various setups.

Confirmed by Tero Roponen <teanropo@cc.jyu.fi> (who had problems with
the 4kB CardBus IO size previously).
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

USB generic driver
When a USB error occurs that might indicate that the device has been
unplugged, don't resubmit the URB immediately to prevent flooding the
log with error messages before khubd has us disconnect()ed.
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>

Add register_sound_special_device() function to allow assignment of
device pointer to a specific OSS device for HAL.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

EMU10K1/EMU10K2 driver
Add identification for Live 5.1 [SB0220]
Signed-off-by: Lee Revell <rlrevell@joe-job.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

EMU10K1/EMU10K2 driver
Added the missing ac97 support on SBLive! Player 5.1.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Intel8x0 driver
Added ac97_quirk for FSC 4010.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

PCM Midlevel
Fixed zero-division bug in PCM 32bit compat layer.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Intel8x0 driver
Signed-off-by: Jaroslav Kysela <perex@suse.cz>

USB generic driver
Emagic devices pad their packets not with 0xff bytes but with a 0xff
byte followed by garbage, so we have to stop at the first such byte.
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>

au88x0 driver,Common EMU synth
Fixed missing spin_unlock.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

GUS Library
'extern inline' doesn't make much sense.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

HDA Intel driver
Fix and clean up for the support of ULI M5461
- set CORB/RIRB sizes explicitly
- add workarounds for ULI on ia32
- max number of streams depends on the chip type now
- increase the size of BDL
Signed-off-by: Takashi Iwai <tiwai@suse.de>

HDA Codec driver
Added the missing beep support for Uniwill laptop (ALSA bug#1358).
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Digigram VX Pocket driver
Add snd_card_set_dev() to register the device pointer.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Digigram VX Pocket driver
Fixed the wrong index number assignment.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Digigram VX Pocket driver
Added the missing event callback.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Memalloc module
Fix an error when built without CONFIG_PROC_FS.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

HDA Codec driver
Use struct instead of array to improve the readability of hda_codec.c.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

HDA Codec driver
The insertion of the rate 9600 make a shift in detection of supported
rate, put this rate at the end of the list.
Signed-off-by: Nicolas Graziano <nicolas.graziano@wanadoo.fr>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Intel8x0 driver,AC97 Codec
The HP nx6110 laptop needs to have Headphone Jack Sense enabled so
that the internal speakers will be turned off when headphones are
plugged in.

Also ac97_quirk=hp_only is needed to make a single Master volume in
the mixer instead of separate volumes for internal speakers and
headphones, which just confuses the user.
Signed-off-by: Sergey Vlasov <vsu@altlinux.ru>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

AC97 Codec
Signed-off-by: Jaroslav Kysela <perex@suse.cz>

AC97 Codec
Signed-off-by: Jaroslav Kysela <perex@suse.cz>

VIA82xx driver
Added the DXS entry for MSI 7142 (K8MM-V).
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Digigram VX core,CS4231 driver,ATIIXP driver,VIA82xx driver
VIA82xx-modem driver,au88x0 driver,CS46xx driver,Trident driver
This patch disables SNDRV_PCM_INFO_RESUME flag for drivers which does not
support the full resume.
Signed-off-by: Jaroslav Kysela <perex@suse.cz>

AC97 Codec
The patch fixes the bus_id conflict error when registering two codecs
of the same type (ALSA bug#1334).
Signed-off-by: Bjorge Dijkstra <bjorge@gmx.net>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

RME9652 driver
Fix the module parameter description after proofreading.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

NM256 driver
- Fixed the PCM resume - restoring the rate setting
- Fixed the handling of buggy irqs
- Dynamically acquire/release irq handler to make the driver more robust
  to unknown irq storms (as OSS driver does).
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Intel8x0 driver
Fixed the PCM resume of intel8x0.
Restores the requested register setting.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Timer Midlevel
Signed-off-by: Jaroslav Kysela <perex@suse.cz>

ALSA Core
Signed-off-by: Jaroslav Kysela <perex@suse.cz>

PCM Midlevel,Timer Midlevel,ALSA Core
- added SNDRV_TIMER_EVENT_SUSPEND / RESUME events
- changed timer events from PAUSE / CONTINUE in PCM midlevel to SUSPEND / RESUME
Signed-off-by: Jaroslav Kysela <perex@suse.cz>

HDA Intel driver
- removed SNDRV_PCM_INFO_RESUME (the driver cannot do PCM resume at the time)
- fixed chip->pcm_devs initialization
Signed-off-by: Jaroslav Kysela <perex@suse.cz>