Merge branch 'topic/sprd' into for-linus

Kconfig and Makefile conflicts so put them in right order (sprd ones after
stm ones)
Signed-off-by: Vinod Koul <vinod.koul@intel.com>

Documentation/devicetree/bindings/dma/sprd-dma.txt

+* Spreadtrum DMA controller
+
+This binding follows the generic DMA bindings defined in dma.txt.
+
+Required properties:
+- compatible: Should be "sprd,sc9860-dma".
+- reg: Should contain DMA registers location and length.
+- interrupts: Should contain one interrupt shared by all channel.
+- #dma-cells: must be <1>. Used to represent the number of integer
+	cells in the dmas property of client device.
+- #dma-channels : Number of DMA channels supported. Should be 32.
+- clock-names: Should contain the clock of the DMA controller.
+- clocks: Should contain a clock specifier for each entry in clock-names.
+
+Example:
+
+Controller:
+apdma: dma-controller@20100000 {
+	compatible = "sprd,sc9860-dma";
+	reg = <0x20100000 0x4000>;
+	interrupts = <GIC_SPI 50 IRQ_TYPE_LEVEL_HIGH>;
+	#dma-cells = <1>;
+	#dma-channels = <32>;
+	clock-names = "enable";
+	clocks = <&clk_ap_ahb_gates 5>;
+};
+
+
+Client:
+DMA clients connected to the Spreadtrum DMA controller must use the format
+described in the dma.txt file, using a two-cell specifier for each channel.
+The two cells in order are:
+1. A phandle pointing to the DMA controller.
+2. The channel id.
+
+spi0: spi@70a00000{
+	...
+	dma-names = "rx_chn", "tx_chn";
+	dmas = <&apdma 11>, <&apdma 12>;
+	...
+};

drivers/dma/Kconfig

@@ -504,6 +504,14 @@ config STM32_MDMA
 	  If you have a board based on STM32 SoC and wish to use the master DMA
 	  say Y here.
 
+config SPRD_DMA
+	tristate "Spreadtrum DMA support"
+	depends on ARCH_SPRD || COMPILE_TEST
+	select DMA_ENGINE
+	select DMA_VIRTUAL_CHANNELS
+	help
+	  Enable support for the on-chip DMA controller on Spreadtrum platform.
+
 config S3C24XX_DMAC
 	bool "Samsung S3C24XX DMA support"
 	depends on ARCH_S3C24XX || COMPILE_TEST

drivers/dma/Makefile

@@ -61,6 +61,7 @@ obj-$(CONFIG_STE_DMA40) += ste_dma40.o ste_dma40_ll.o
 obj-$(CONFIG_STM32_DMA) += stm32-dma.o
 obj-$(CONFIG_STM32_DMAMUX) += stm32-dmamux.o
 obj-$(CONFIG_STM32_MDMA) += stm32-mdma.o
+obj-$(CONFIG_SPRD_DMA) += sprd-dma.o
 obj-$(CONFIG_S3C24XX_DMAC) += s3c24xx-dma.o
 obj-$(CONFIG_TXX9_DMAC) += txx9dmac.o
 obj-$(CONFIG_TEGRA20_APB_DMA) += tegra20-apb-dma.o